Watching - Panasonic TX-40JX800B Operating Instructions Manual

Set up your Wi-Fi network and Google account
If you are using an Android phone for setup, select
[Continue]. You can then easily transfer your Android
phone's Wi-Fi network and Google account to your
TV.
If you are not using an Android phone for setup,
select [Skip], then complete settings on the setup
screen which appears next.
When using an Ethernet cable to connect to the
internet, select [Skip], then select [Use Ethernet] on
the Wi-Fi network settings screen.
Select your country
Enter the PIN number for parental controls
Select [Scan]
Select [Home]
Select [Home] for use in a home viewing environment.
[Shop] is for shop display.
To change the viewing environment later on, the set
will need to have all settings initialised by accessing
[Reset].
Initial Setup is now complete and the
TV is ready for viewing.
If tuning has failed check the RF cable, and the network
connection, and then follow the on-screen instructions.
Note
The TV goes into Standby mode when no operation
is performed for 4 hours if [Switch Off Timer] in the
Power menu is set to [240 Minutes] (factory setting).
The TV goes into Standby mode when no signal is
received and no operation is performed for
10 minutes if [No Signal Power Off] in the Power
menu is set to [10 Minutes] (factory setting).
To retune all channels
[Channel Scan] (Settings > Channel >
Channels)
To initialise all settings
[Reset] (Settings > Device Preferences > About)
Watching TV
1
Turn power on
(TV)
or
(Remote Control)
Mains power On / Off switch should be on.
(p. 18)
2
Select TV
TV
3
Select a channel
up
down
or
To select a channel position with 2 or more-digit, e.g.
399
19
English