Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for LogiLink AU0002E
Summary of Contents for LogiLink AU0002E
-
Page 2: Safety Instruction
In any case, liability for loss of data is limited to the effort that is necessary to restore from existing backup copies. Congratulations to the Purchase of AU0002E ! Please read the Manual and Safety Instructions before using the product for the first time. Otherwise damage can be the result. -
Page 3: Specification
2.0 Introduction AU0002E can connect your serial device through USB. With the Logilink USB Serial Adapter AU0002E, you connect a 9-pin serial device such as Joystick, PDAs, cellular phones, digital cameras, modems or ISDN terminal adapter through a free USB port on your computer. -
Page 4: Software Installation
4. After installation, please click ”OK ” 3.2 Hardware Installation 1. Plug in the USB-Serial cable AU0002E into the USB port and run the Found New Hardware Wizard to assist you in setting up the new device. 2. Click ‘Next’ to continue. - Page 5 3. Select the “ Search for a suitable driver for my device (re-command) “ 4. Windows starts to detect the driver and Click ‘Next’ to continue installation. - 4 -...
- Page 6 5. Click ‘Finish’ to continue and let Windows copy the needed files to your hard disk. 6. After finish, you can to check the Device Manager and find the Prolific USB to Serial Comm Port (see picture as below). - 5 -...
- Page 7 3.3 How to Change COM Port 3.3.1 Under Windows 98SE – You can change the COM Port via setcom.exe software 3.3.2 Under Windows Me/2000XP – Kindly following the steps as below. 1. Please click on the Device Manager\ Devices by connection \ ports (COM &...
- Page 8 (Images 2) 3. Please choose "Port Settings ", and then click on "Advanced". Please choose the needed com, and click on" ok”. ( see images 3) (Images 3) Notice: If the Modem could not link with the new port, and run smoothly when changed the port, please un-install Modem, and re-install it.
- Page 9 (ie: Modem) to the USB port of your PC: 1. Turn off your Serial Device (ie: Modem). Plug the DB 9P connector of the USB-Serial cable AU0002E into your Modem. Turn on the Modem afterwards. 2. Turn on your computer and plug in the USB connector of the USB-Serial cable into the USB port.
-
Page 10: Uninstalling The Driver Program
CD-ROM, then reboot the PC. CE Declaration: This device corresponds to EU directive 2004/108/EC: With the CE sign Logilink®, a registered trademark of the 2direct GmbH ensures, that the product is conformed to the basic standards and directives. These standards can be requested online on www.logilink.com.