Page 1
& ILLUSTRATED PARTS LIST MODEL: 73-70642 POWER BLOWER PB100 WARNING: If incorrectly used this machine can cause severe injury. Those who use and maintain this machine should be trained in its proper use, warned of its dangers and should read the entire manual before attempting to set up, operate, adjust or service the machine.
Page 2
CALIFORNIA WARNING Proposition 65 Warning The engine exhaust from this product Diesel engine exhaust and some of contains chemicals known to the State its constituents are known to the State of California to cause cancer, birth of California to cause cancer, birth defects or other reproductive harm.
BLOWER IMPORTANT MESSAGE Thank you for purchasing this Jacobsen product. You have purchased a world class product, one of the best designed and built anywhere. This product comes with an Owner/Operator's Manual. The useful life and good service you receive from this product depends to a large extent on how well you read and understand this manual.
INTRODUCTION/SPECIFICATIONS POWER BLOWER DESCRIPTION Use the Power Blower to clear leaves and the most stubborn debris from lawns, parking lots, driveways or golfcart paths quickly and easily. The airflow is equal to a 150 MPH wind. It will also blow away water laying on paths and golf greens.
Jacobsen machines. For your safety and the safety manner not specifically authorized after original of others, read and follow the information given with manufacture–including the addition of “after-market”...
Page 6
SAFETY POWER BLOWER GENERAL SAFETY 1. Read and understand the Owner’s Manual before attempting to operate this machine. 2. Operate all controls from the operator’s seat. NO RIDERS. 3. Keep all shields in place and safety switches adjusted properly. 4. Do not leave equipment unattended. STOP the engine and remove the key. 5.
OPERATION POWER BLOWER 5. Observe the wind direction and work with the 1. Attach blower to quick hitch front lift, placing wind whenever possible. The blower works drive belt around the left hitch arm. equally well when traveling forward or reverse. 2.
9. Check all bolts and pulleys. Tighten as needed. Rotate the blower rotor and check for free rotation. NOTE: This is a high speed balanced rotor and care must be taken to have clearance within the housing to avoid damage to rotor or premature failure of parts. If any interference is found contact your Jacobsen dealer.
DISCHARGE CHUTE POWER BLOWER FIGURE 2 ITM PART NO. DESCRIPTION ITM PART NO. DESCRIPTION 60-411.7 SHIELD-FRONT BEARING 64139-08 BOLT-5/16-18X3/4 WLF 41-051 SPRING 64141-6 NUT, 5/16-18 64-496.7 HINGE PLATE-CHUTE 02-CP0506 COTTER PIN-5/32 X 3/4 42-396 HNGE PIN 62-623.7 DISCHARGE CHUTE 42-397 SPRING LINK 10 64163-61 WSHR .81X.406X16GA...
Page 14
Equipment from Jacobsen, a Textron company, is built to exacting standards ensured by ISO 9001 and ISO 14001 registration at all our manufacturing locations. A worldwide dealer network and factory-trained technicians backed by Textron Parts Xpress provide reliable, high-quality product support.
Need help?
Do you have a question about the PB100 and is the answer not in the manual?
Questions and answers