The power supplied to the LED illuminator is intrinsically safe. See figure 1. Figure 1: Typical Layout 16633 Foltz Parkway ● Strongsville, OH 44149 USA ● Telephone: +1 (440) 572-1500 ● Fax: +1 (440) 238-8828 www.clark-reliance.com ● sales@clark-reliance.com...
Page 3
5) Refer to the troubleshooting section in this manual if a portion or all of the LEDs do not illuminate. Led Illuminator with Field-Wireable Connector 1) Disassemble the field-wireable connector. See figure 3. Figure 3: Field Wireable Connector 16633 Foltz Parkway ● Strongsville, OH 44149 USA ● Telephone: +1 (440) 572-1500 ● Fax: +1 (440) 238-8828 www.clark-reliance.com ● sales@clark-reliance.com...
The window may be cleaned while the unit is in operation. 16633 Foltz Parkway ● Strongsville, OH 44149 USA ● Telephone: +1 (440) 572-1500 ● Fax: +1 (440) 238-8828 www.clark-reliance.com ● sales@clark-reliance.com...
Page 5
Note that all one-section size 7 models and smaller will require the power supply to be remote mounted. 16633 Foltz Parkway ● Strongsville, OH 44149 USA ● Telephone: +1 (440) 572-1500 ● Fax: +1 (440) 238-8828 www.clark-reliance.com ● sales@clark-reliance.com...
Page 6
Pull the cable loop as tight as possible and fully tighten the thumb nut down as shown in Figure 6. The lower bracket should now be tight and secure. 16633 Foltz Parkway ● Strongsville, OH 44149 USA ● Telephone: +1 (440) 572-1500 ● Fax: +1 (440) 238-8828 www.clark-reliance.com ● sales@clark-reliance.com...
Page 7
This adjustable assembly is appropriate for any gauge with a cover width not exceeding 4.375 inches (111 mm). 16633 Foltz Parkway ● Strongsville, OH 44149 USA ● Telephone: +1 (440) 572-1500 ● Fax: +1 (440) 238-8828 www.clark-reliance.com ● sales@clark-reliance.com...
Page 8
Roll the entire assembly over until it is flush with the rear flat of the gauge and press until the bracket clips have locked into place as shown in Figure 12. 16633 Foltz Parkway ● Strongsville, OH 44149 USA ● Telephone: +1 (440) 572-1500 ● Fax: +1 (440) 238-8828 www.clark-reliance.com ● sales@clark-reliance.com...
Page 9
4) Position illuminator so it is centered on the Reflex Gauge and tighten the bracket thumb screws. The illuminator should be mounted as shown in Figure 13. Reflex Bracket Mounting Figure 17 16633 Foltz Parkway ● Strongsville, OH 44149 USA ● Telephone: +1 (440) 572-1500 ● Fax: +1 (440) 238-8828 www.clark-reliance.com ● sales@clark-reliance.com...
Need help?
Do you have a question about the Jerguson LumaStar EPL-100 and is the answer not in the manual?
Questions and answers