Kenwood NX-200 Service Manual page 100

NX-200
Item
Panel tuning mode
13. VOX1 1) Adj item: [VOX1]
adjust Adjust: [✳✳✳]
AG: 1kHz/45mV at
MIC terminal
14. VOX10 1) Adj item: [VOX10]
adjust Adjust: [✳✳✳]
AG: 1kHz/3mV at
MIC terminal
15. BATT 1) Adj item: [BATT]
detection Adjust: [✳✳✳]
writing PTT: ON
16. BATT [Panel test mode]
detection 1) CH-Sig: 1-1
check BATT terminal
voltage: 6.0V while
transmitting
100
ADJUSTMENT
Condition
PC test mode
equipment
1) Adj item: [VOX1] AG
AG: 1kHz/45mV at
MIC terminal
1) Adj item: [VOX10]
AG: 1kHz/3mV at
MIC terminal
1) Adj item:[Battery Power
Warning Level] meter
PTT: Press DVM
[Transmit] button.
1) Test Channel
Channel: 1
Test Signaling
Mode: Analog
Signaling: 1
BATT terminal
voltage: 6.0V while
transmitting
Measurement
Test-
Unit Terminal Unit
Panel Universal
connector
Panel ANT
BATT
terminal
Adjustment
Specifi cations /
Parts Method
[Panel tuning mode]
After apply signal
from AG, press [ ]
key to store the
adjustment value.
[PC test mode]
After apply signal
from AG, press
[Apply] button to
store the adjust-
ment value.
Press the PTT
switch or [Transmit]
button on the PC
window.
Apply 6.20V to bat-
tery terminal.
Confi rm that one
pre-determined nu-
meric in the range 1
to 256 appears.
[Panel tuning mode]
Press [ ] key to
store the adjust-
ment value.
[PC test mode]
Press [Apply] but-
ton to store the
adjustment value.
Check The transceiver
can transmit with
causing the LED to
blink.
Remarks