Connection On The Back - Conrad Electronic MC Crypt Operating Instructions Manual

Connection
Pin assignment of the connections on the front of the device:
Jack plug

Connection on the back

On the back of the device, there are 2 loudspeaker connections, an insert socket (for looping exter-
nal devices in the signal path) and a tape loop for connecting recording devices.
The total impedance of the connected loudspeakers should not be less than 4 ohm.
You can connect either two 8 Ohm loudspeakers or one 4 Ohm loudspeaker.
• Connect your loudspeaker with the connections SPEAKER OUTPUT (17).
• Connect the device that you want to loop into the signal path between the mixing desk and the
integrated amplifier with the connection MAIN OUT/AMP IN (18).
• Connect the playback outputs of your recording device with the connection TAPE IN (19).
• Connect the recording inputs of your recording device with the connection TAPE OUT (20).
22
Earth
XLR socket (seen from contact side):
Earth