Circle Prime Manufacturing CP-03318 Quick Start Manual

EXTREME CAUTION SHOULD BE TAKEN WHEN MOUNTING THESE COMPONENTS TO THE
BUILDING. AVOID POWER LINES & FOLLOW ALL LOCAL INSTALLATION CODES FOR
KIT INCLUDES:
Item Description
1. INTEROPERABLE AMPLIFIED
ANTENNA ON A BRACKET (CP-03264)
2. J-POLE, VAPOR WRAP, 2 TIE WRAPS, &
U-BOLT. (CP-03265)
3. ONE - 100' RG-58 TYPE CABLE (CP-
03247)
4. TWO – 200' RF 195 LOW LOSS TYPE
CABLE (CP-03249)
5. TWO - 41 dB IN-LINE AMPLIFIER
(CP-03243)
CAUTION: 1) Do not cut the supplied cables nor increase cable length by inserting additional cable
sections. Adjusting the length of any of the cables will degrade signal performance.
2) Maximize separation between In-Line Amplifers.
3) Completely uncoil the 100' and both 200' cable assemblies and route them by opening
to their full extended length. Do not leave unused cable coiled near the In-line
Amplifiers.
4) Verify that the In-line Amplifiers are spaced by a minimum physical separation of 30'.
5) Verify that one active 4 way splitter with DC power output is connected to output port
1 on the 4 way passive splitter. (See Figure 1 below)
INSTALLATION INSTRUCTIONS:
1. Take the antenna and mount it to the J-pole as shown below, with the supplied U-bolt. Attach the J-
pole to the top or side of the building and secure as necessary. Make certain the amplified antenna is
horizontal.
2. Attach the 100' cable to the antenna and wrap this connection with the supplied vapor wrap. Attach
the cable to the J-pole to secure it with the supplied tie-wraps.
3. Feed cable through building and towards the receivers.
4. Attach the first in-line amplifier to the 100' cable. Ensure that the output port of the amplifier is left
open to connect the next cable down line.
5. Connect the first 200' cable to the open port of the in-line amplifier. Attach this cable to the side of
the in-line amplifier that has the label stating "OUT TO RECEIVER". Feed the 200' cable towards
the location of the receivers. Add the second in-line amplifier and second 200' cable following the
same procedure.
6. Feed cable through building and towards the receivers.
7. Attach the INPUT of the passive 4-way splitter to the open end of the last 200' cable.
FOR TECHNICAL SUPPORT CALL 330-923-0019
INTEROPERABLE SATELLITE RADIO
500 FT.; SIXTEEN RECEIVER SYSTEM
INSTALLING THIS TYPE OF EQUIPMENT.
6. ONE – 4 WAY PASSIVE SPLITTER
(CP-03283)
7. FOUR – 10' RG-58 LOW LOSS TYPE
CABLE (CP-03293-2)
8. FOUR – 4 WAY ACTIVE SPLITTER,
w/SMB OUTPUT (CP-03263)
Parts needed; that are not supplied.
• Six 5/16 X 3" lag screws to mount pole to
building
• Six 5/16" washers
• Hardware to properly ground the system.
• Addition straps to support cable along
beams.
WWW.CIRCLEPRIME.COM
Model CP-03318