Sonic Soul Fast Assembly And Care

Sonic Soul Fast Assembly And Care

Advertisement

Assembly and Care for your new

Part 1: Assembly

1. Unbox and unpack your new bike.
1. There are two to three items to look for in your bike box
1. The bike
2. The main parts box - there may be a secondary parts box dependent on model
ordered
3. Pedals in box
4. Seat and post
2. Upon removal of the bike and assorted parts boxes, please remove the protective
packing materials, zip ties and plastics. Take care not to cut any cables or brake hoses.
3. Inspect for any damage during shipment.
2. Organizing the assembly - You will have the following parts/components:
1. The main bike frame assembly
2. Fork
3. Front wheel
4. Handlebars
5. Stem
6. Seat/seat post
7. Seat clamp (usually pre-installed onto frame, or if a rear rack is involved there is a
secondary clamp)
8. Headset parts
9. Pedals
10. Reflectors
Soul Fast eBike

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Soul Fast and is the answer not in the manual?

Questions and answers

Summary of Contents for Sonic Soul Fast

  • Page 1 Assembly and Care for your new Soul Fast eBike Part 1: Assembly 1. Unbox and unpack your new bike. 1. There are two to three items to look for in your bike box 1. The bike 2. The main parts box - there may be a secondary parts box dependent on model ordered 3.
  • Page 2 11. Bike spikes (If equipped) 3. Assemble the bike from front to rear: Fork and Headset 1. Find the fork and headset parts 2. The bearings and seals are pre-installed into the frame 3. Make sure the cables and brake hoses are on the non drive side of the bike 4.
  • Page 3 5. If the seat post clamp is not installed on the frame, install it at this time. 6. Take the seat and seat post and insert it into the frame. 7. Tighten the quick release to allow the cam actuation to lock the post into the frame so that it cant twist easily.
  • Page 4 Headset This is the easiest adjustment. If the slack of the stem and spacers on the fork is removed, then we need to fine tune the tension. Loosen the 2 6mm pinch bolts on the stem to allow the stem to move With a 5mm Allen, add tension to the top cap To test proper tension, lock the front brake ONLY and rock the bike forward and backward.
  • Page 5 Tires We prefer the tire pressure to be set at 30 psi. Out of the box, the pressure is usually at 10 psi. Adding 5 pounds at a time, slowly inflate the tires. Ensure that the tire seats evenly on the rim.
  • Page 6 While electric bikes can certainly get wet we recommend trying to stay out water as much as possible. If heavier dirt or mud is present, you can hose the bike off but refrain from spraying any jets of water at the components or bearings. We recommend using microfiber cloth and mild cleaners like window cleaner for general cleaning.

Table of Contents