Start Up - PRETUL HILA-1800P User Manual

Turning ON
• Open the water faucet. Keep it open while using the pressure washer.
• Completely untangle the power cable and connect the plug into the power supply. In this step, do not turn ON the
pressure washer.
• Press and hold the high-pressure gun trigger to release the air trapped inside the pressure washer. Release the
trigger when the water flows constantly.
• Turn the switch into position I (ON). The motor will start momentarily and then, it will stop.
1 2
Using standing water
• To use standing water instead of running water, set the standing water container at
least 1 meter high regarding the ground level. It is necessary to have a safe and
adequate connection (flexible hose).
• Before operating the pressure washer, double check the high-pressure hose is
disconnected.
• Connect the flexible hose coming out of the standing water container into the
pressure washer inlet. Verify the flow into the pressure washer is constant.
• Turn ON the pressure washer until water starts flowing. Leave the pressure washer
ON one minute maximum.
• Turn OFF the pressure washer and connect the high-pressure hose. Now, you are
ready to use the pressure washer.
WARNING • It is important that the standing water container is full all the time.
Using the pressure Washer dry more than 2 minutes will damage the high-pressure
pump and it is not cover with the Warranty.
Spraying
• Press the gun trigger to start spraying.
• To stop spraying, just release the trigger.
• The gun has a blocking button (A) to prevent
accidental spraying. Pointing the gun to the front, the
button will show to the left when the trigger is blocked
and to the right, when it is released.
Lance Nozzle
Increase pressure
Decrease pressure
8
ENGLISH
3
• Adjustable mist nozzle:
Turn the nozzle to open or close the mist angle.
The mist, with the open angle encompasses a wider surface and is ideal to rinse
surfaces.
With the angle closed, mist is aimed to one point and is ideal to clean.
• Turbo spray nozzle:
High-pressure mist pattern for optimal cleaning. Keep the nozzle at a 8"
minimum distance from the surface to be washed.

Start Up

4
Trigger
A