Advertisement
4.1.5.
screw fix one bracket to the chosen surface using fixings that are appropriate to the substrate and strong enough to carry the weight
of the reel plus the working strain exerted on it when in use. Position the hose reel onto the first bracket, then proceed to fix the
second bracket into place and ensure the reel is secure.
4.1.6.
Connect the air supply to the reel using a flexible hose sufficiently long to allow the reel to swivel 180° from side to side.
Wall mounting
5. operatioN
5.1.
Pull out the hose to the required length. A clicking noise will be heard every half revolution of the drum.
5.2.
to latch the reel, allow the reel to slowly retract after hearing the 1st, 2nd or 3rd click.
5.3.
to unlatch the reel, slowly pull out the hose until the clicking noise stops, then let the hose slowly retract until the hose stopper rests
against the reel mouth.
Note: remove tools from the hose when they are no longer required for use. the reel is not designed to retract with tools attached
to it nor should heavy air tools or tools in general be left hanging on the hose. tool balancers should be used with heavy air tools.
WarNiNG! to prevent injury or damage occurring, do not let go of the hose during rewinding.
‰
6. MaiNteNaNce
WarNiNG! Before carrying out routine maintenance or inspection, vent any pressure remaining in the hose.
‰
6.1.
the hose reel does not require special maintenance as it is lubricated for life. to ensure reliable operation, clean the hose and
casing regularly. Do Not spray or wet the product, but clean with a cloth and warm water. Do Not use solvents or detergents, as
these may permanently damage the plastic.
6.2.
there are no user serviceable parts. All maintenance and repairs which require the case to be opened or dismantled should be
carried out by an authorised service agent only.
WarNiNG! Do Not dismantle the hose reel casing, or attempt to remove the screws and covers on the sides. to do so may result in
‰
damage to the appliance and/or personal injury and will invalidate the warranty.
should you wish to store the air hose, ensure it is clean and dry. Place the item in a dark, safe, dry, childproof location, where the
temperature will remain reasonably stable. Do Not store in a nylon or plastic bag, as this will encourage condensation.
7. MaiNteNaNce
ProBlem
Hose will not retract:
reel will not latch
reel leaks
parts support is available for this product. to obtain a parts listing and/or diagram,
please log on to www.sealey.co.uk, email sales@sealey.co.uk or telephone 01284 757500.
environmental protection
recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be
sorted, taken to a recycling centre and disposed of in a manner which is compatible with the environment.
When the product becomes completely unserviceable and requires disposal, drain off any fluids (if applicable)
into approved containers and dispose of the product and the fluids according to local regulations.
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
iMportaNt: no liability is accepted for incorrect use of this product.
WarraNty: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
PossiBle cAuse
Hose bunching within reel.
spring tension too tight. replacement hose
too heavy. the hose has been pulled past
the latching teeth. Broken latching pawl or
pawl spring.
damaged hose. loose air connection. Worn
swivel seals.
ceiling mounting
solution
Pull hose out of reel and guide back in.
Have spring tension adjusted by authorised
service agent. Have correct hose fitted by
authorised service agent. Allow reel to retract
slowly after hearing 1st, 2nd or 3rd click.
Have new latching pawl or pawl spring fitted
by authorised service agent.
Have new hose fitted by authorised service
agent. tighten fitting. Have new seals fitted
by authorised service agent.
Advertisement
