Summary of Contents for Chapman TH200
- Page 1 TH200 Tine Harrow Original Instructions Chapman Machinery Ltd, Hele Barton, Week St. Mary, Holsworthy, Devon EX22 6XR Tel: 01288 308149 Email: sales@chapman.co.uk...
-
Page 2: Table Of Contents
The information contained in this manual is correct at the time of going to press. However, in the course of development, changes in specification are inevitable. Should you find the information given differs from your machine, please contact Chapman Machinery Ltd direct for advice. Use only Chapman Genuine Service Parts on Chapman Machinery and Machines. -
Page 3: Hse Information
HSE Information Safe use of all-terrain vehicles (ATVs) in agriculture and forestry – AIS Sheet 33 within these requirements. Introduction Remember that your ability to control the ATV by your body movements will be considerably reduced when carrying a load or This information sheet gives advice on the safe use of ATVs. -
Page 4: Important Safety Information
Important Safety Information Always read this manual before fitting or operating the machine – whenever any doubt exists contact your dealer or the Chapman Machinery Service Department for advice and assistance. DEFINITIONS The following definitions apply throughout this manual: WARNING - An operating procedure, technique etc., which can result in personal injury or loss of life if not observed carefully. -
Page 5: Description
The TH200 Tine Harrow is a trailed attachment, with 4 rows of spring tines. The angle of attack of the spring tines can be adjusted in 3 increments from soft to aggressive. The height of the unit can also be adjusted using the electric actuator, to change between working and transport modes. - Page 6 Component Identification Page 6...
-
Page 7: Attachment
Initial Set-up Tine Angle The tines on the TH200 can be set to three settings of aggressiveness, using the black tine bar adjuster located just behind the machine drawbar. Pulling the adjuster forwards (towards the towing vehicle) will make the tines less aggressive and pushing the adjuster rearwards will make the tines more aggressive. The adjuster s fixed in place once set using a pin and retaining clip. -
Page 8: Initial Test Operation
During this period the angle of the drawbar should be adjusted to suit the towing vehicle, such that the main frame of the TH200 runs level with the ground when the unit is in a working height. -
Page 9: Storage
Storage For extended periods of storage, it is advisable that the machine be kept in a clean dry environment protected from the elements to avoid risk of corrosion. Troubleshooting Problem Possible Causes Remedies Unit will not raise or lower Shortage in wiring (may be Check plug and battery connection are free from dirt and making good indicated by unit losing power when... -
Page 10: Warranty
Transfer of Warranty The Chapman warranty be transferred to a subsequent owner of the machinery (for use within the UK only) for the balance of the warranty period subject to all of the stated warranty conditions and provided that the Change of Owner form is completed and sent to Chapman Machinery within 14 days of change of owner- ship. - Page 11 Chapman Machinery Ltd Hele Barton Week St. Mary Holsworthy Devon EX22 6XR The Products Covered by this Declaration Product: TH200 Tine Harrow Standards and Regulations used: Machinery Directive 2006/42/EC Place of Issue: United Kingdom Name of Representative: James Chapman Position of representative:...