User Manual; Attaching The Backrest; Adjustment Of Seat Height (With El); Placement Of Plug (With El) - VELA Medical Basic+ Manual

2.0. USER MANUAL

1.
2.
EL
EL
EL
1 0
Replacement of the gas spring may only be performed
by the service support team from your dealer or a
skilled technical person.

2.0.1. ATTACHING THE BACKREST

The lever for backrest adjustment (1) must be in open position.
Press the locking pin spring (2) and push the backrest arm
through the hole. Tighten the lever afterwards.
Note: The backrest arm must be pushed through completely
so the pin spring locks the backrest arm. Make sure that the
backrest arm cannot be pulled out again.
2.0

.2. ADJUSTMENT OF SEAT HEIGHT (WITH EL)*

Is operated by pressing your foot down on the contacts placed
on the front wheel towers. Press the right contact to lift the
seat, and press the left contact to lower the seat.
.3. ADJUSTMENT OF SEAT HEIGHT (WITH EL)*
2.0
Is operated by pressing your heel towards the front edge of the
foot plate. Press the right side of the front edge to lift the seat,
and press the left side of the front edge to lower the seat.

.4. PLACEMENT OF PLUG (WITH EL)*

2.0
The plug is located in the left side of the footplate (under the
seat). The plug can be removed and is used for charging the
chair.
Note: Height function may only be used continuously for two
minute, then nine minutes of break.