Table of Contents
Advertisement
Installation Guide
H/U952T Terminal Transmitter
Appendix B: Coaxial Connectors
When connecting the antenna cable to the transmitter the TNC coax connector for
soldering is preferable to use, but an TNC-UHF adapter can be ordered from your supplier
if for example the antenna cable already is equipped with a PL259 (UHF) connector.
TNC Angle connector
Figure 16. TNC connector and TNC-UHF adapter.
Assemble TNC Coax Connector as follows:
Figure 17. Assembly of TNC coax connector.
1
Cut and strip cable as shown in figure at (1).
2
Slide nut, clamprings and gasket onto cable.
3
Push shank cone between braid and cable sheat until stop (2).
4
Insert cable into housing and screw on the nut.
5
Solder the inner conductor (3).
2002-11-13/ Rev. A
TNC - UHF adapter
TD 92022GB
13
Advertisement
Table of Contents
