Honeywell EIM Training page 7

Programming Redlink for EIM Module
• 1.)Follow instructions that come up on screen when
new thermostat is first installed or reset to factory
default settings then follow instructions.
• 2.)Go through thermostat until thermostat reads:T-Stat
Controls an Equip Module:NO switch using arrow keys
to yes. Next hit yes then next says to press connect at
EIM Module. Press connect and wait to see green LED
start flashing then go to thermostat and hit next.
Should say connecting, once connected thermostat will
say connected, hit next and you have now linked
thermostat to Module.