Sunstream RC306 Quick Start Manual

How to program your remote control

Section #1 - RC306

If you have a handheld with 2 blue up/down buttons and 1 additional button then use these instructions
to reprogram the handhelds. If your lift is less than 1 year old and you have different looking handheld
and base unit, please see section 2. If this procedure does not work, please contact us for a replacement
which may be covered under warranty. The base unit up/down controls should always work even if the
handhelds do not.
Locate the following : 1/ Base unit found inside the white PowerPack box, 2/ Handheld units/FOBs
Here is how you reprogram the remotes should your handhelds lose the pairing or if we replaced your
base unit and did not have your handhelds. 1 st make sure your main 12v Deep Cycle battery is strong.
Step # 1 – press and release the red button on the side of the base unit – as shown below
Step 2 – press the blue 'up' button on the handheld remote control 3-4 times. The 4 th press should
activate lift. If you try this procedure a couple times and your handheld still will not pair with the base
unit, then we can provide a replacement that may be under warranty.
Repeat for each remote that you want to pair to that base unit. If you have a handheld that controls
more than one lift at the same time, then press and hold the red bottom on the side of the base unit for
15 sec. And it will clear all the handhelds. After clearing all handhelds for that lift, reprogram the
correct handheld to that lift using the above procedure in Step #1.