Page 2
This drawing remains the property of D.W. TOP VIEW PROJECTION REAR VIEW 11:05 AM Boss Aluminium P/L and must not be THIRD ANGLE Drawn copied or reproduced in any way or form BOSS This drawing remains the property of Sheet 1 Rev.
Page 3
BOSS RT1 MOUNTING • There are 2 slotted mounting rails that must be used to mount the tent. • Use 8 M8 bolts (4 on each side) to secure the tent to your mounts. INSIDE MOUNTS 1060.0 • Ensure your mounts are adequite and hardware is tight.
Page 4
CANVAS CARE Before Use: New canvas should be thoroughly wet before use and allowed to dry. • Boss Aluminium has wet the canvas once • Repeat an additional 2-3 times to ensure sealing up of the seams. Maintaining Canvas Quality: Clean only with cold water and brush - do not use soap or detergent.
Page 5
CANVAS SPECIFICATIONS WEIGHT: • Dynaproofed: 275g/sq.m (8 oz) +/- 30gsm CONSTRUCTION: • Woven 65/35 Poly/Cotton Pla in Weave Japara • 39.4 ends per cm. 26.8 picks per cm. Yarn Count: • 1/20 ECC x 1/20 ECC Maximum Shrinkage • 2% in Warp Tear Resistance: •...
Page 6
TELESCOPIC LADDER Precautions • Top of ladder and roof top tent locating pins are non-load bearing • Do not stand on the top 3 steps/rungs • Do not exceed 75° • Ensure ladder is on an even, level and unmovable base •...
Page 7
Use of the ladder • Do not exceed the maximum total load. • Do not overreach. Users should keep the trunk of their body inside the stiles, with both feet on the same step/rung throughout the task. • Do not step off a leaning ladder at a higher level without additional security, such as tying off, or the use of a suitable stability device.
Page 8
Opening the Ladder With automatic locking, each rung of the ladder has 2 locking pins that are blocked, which are automatically inserted into the slots of the uprights when the ladder is extended. The condition of the lock is indicated by the two black buttons on the side of each rung, as shown below: Complete Extension of the Ladder 1.
Need help?
Do you have a question about the RT1 and is the answer not in the manual?
Questions and answers