Advertisement
Safety Information
Important information - please read carefully
CAUTION!
RISK OF ELECTRIC SHOCK
DO NOT OPEN
TO REDUCE THE RISK OF ELECTRIC SHOCK DO NOT REMOVE COVER (OR BACK)
NO USER-REMOVEABLE PARTS INSIDE
REFER SERVICING TO QUALIFIED PERSONNEL
This equipment is a Class II or double insulated electrical appliance. It has been designed in such a way that it
does not require a safety connection to electrical earth.
Read and keep these instructions.
Heed all warnings and follow all instructions.
Do not use this apparatus near water.
Clean only with a dry soft cloth.
Do not block any ventilation openings.
Install
in
accordance
with
the
manufacturer's
instructions.
Do not install near any heat sources such as radiators,
heat registers, stoves, or other apparatus (including
amplifiers) that produce heat.
Protect the mains power cord from being walked on or
pinched, particularly at plugs, convenience receptacles,
and the point where they exit from the apparatus.
Use only attachments/accessories specified by the
manufacturer.
Use only with the cart, stand, tripod, bracket, or
table specified by the manufacturer, or sold with the
apparatus. When a cart is used, use caution when
moving the cart/apparatus combination to avoid injury
from tip-over.
Unplug this unit during lightning storms or when
unused for long periods of time.
Do not defeat the safety purpose of the polarized or
grounding type plug. A polarized plug has two blades
with one wider than the other. A grounding type plug
has two blades and a third grounding prong. The wider
blade or the third prong are provided for your safety. If
the provided plug does not fit into your outlet, consult
an electrician for replacement of the obsolete outlet.
No naked flame sources such as candles should be
placed on the product.
Batteries (a battery pack or installed batteries) shall not
be subject to excessive heat such as sunshine, fire or the
like.
Take note of all warnings on the appliance, under no
circumstances disassemble the unit or remove covers to
prevent the risk of fire or electrical shock.
This symbol indicates that there are important
operating and maintenance instructions in the
literature accompanying this unit.
This symbol indicates that dangerous voltage
constituting a risk of electric shock is present
within this unit.
The mains operating voltage of this unit is marked on a
rating plate on the back of the unit. Before connecting
to mains power, check that the voltage is the same as
your mains supply.
Caution: Changes or modifications not expressly
approved by the manufacturer could void the user's
authority to operate this device.
Caution: Usage of controls or adjustments or
performance of procedures other than those specified
herein may result in hazardous exposure.
Warning: The AC Input connector is used as a safety
disconnect device. It must be easily accessible after
installation.
Warning: To reduce the risk of fire or electrical shock, do
not expose this product to rain or moisture. The product
must not be exposed to dripping and splashing and no
object filled with liquids such as a vase of flowers should
be placed on the product.
To avoid the danger of suffocation, keep all polythene
bags and packaging away from babies and children.
Third parties: In the unlikely event that you pass this
product on to a third party, include these operating
instructions with the product.
Correct disposal of this product
This marking indicates that this product
should not be disposed of with other
household wastes throughout the EU. To
prevent possible harm to the environment
or human health from uncontrolled waste
disposal, recycle it responsibly to promote the
sustainable reuse of material resources. To return your
used device, please use the return and collection
systems or contact the retailer where the product was
purchased.
They
can
take
this
product
environmentally safe recycling.
1
Safety Information
Service
Refer all servicing to qualified service personnel.
Servicing is required when the unit has been damaged
in any way, such as the power supply cord or plug is
damaged, liquid has been spilled on or objects have
fallen into the unit, the apparatus has been exposed to
rain or moisture, it does not operate normally or it has
been dropped.
Notes
FCC Statement (For US Customers)
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired
operation.
This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant
to part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful
interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy
and if not installed and used in accordance with the
instruction manual, may cause harmful interference
to radio communications. However, there is no
guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful
interference to radio or television reception, which can
be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference
by one or more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between equipment and
receiver.
•
Connect the equipment into an outlet on a
circuit different from that to which the receiver is
connected.
•
Consult the dealer or an experienced radio/TV
technician for help.
CAUTION! Any changes or modifications made to
this device that are not expressly approved by the
manufacturer may void the user's authority to operate
the equipment.
This equipment complies with FCC radiation exposure li
for
mits set forth for an uncontrolled environment.
This equipment should be installed and operated with
minimum distance 20cm between the radiator &
your body.
Equipment for servicing should be returned to the
supplying dealer, or to the service agent for your area.
The address of the main Service Agent for the UK is
listed at the back of this manual.
Important notice for UK users
The UK mains lead is terminated with a UK approved
mains plug fitted with a 3A fuse. If the fuse needs to be
replaced, an ASTA or BSI approved BS1362 fuse rated at
3A must be used.
Industry Canada Statement (for Canadian
Customers)
CAN ICES-3 (B)/NMB-3(B)
The device meets the exemption from the routine
evaluation limits set out in section 2.5 of RSS 102 and
is in full compliance with RSS-102 RF. Users can obtain
information on RF exposure and compliance from
Industry Canada.
This device complies with Industry Canada licence-
exempt RSS standard(s). Operation is subject to the
following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received,
including interference that may cause undesired
operation.
2
Advertisement
