Page 2
PARTS LIST: A. Seat (with back legs) Qty: 1 B.Right Arm (with front leg) Qty: 1 C. Left Arm (with front leg) Qty: 1 D. Stringer Qty: 1 E. Back Qty: 1 HARDWARE LIST: Screws Qty: 30 Note: Read these instructions carefully before assembling. ...
Page 3
Step 1: Set the Seat (A) with attached back legs on the shipping carton with the Seat facing down. Using the factory-installed screw as a pivot, rotate the back legs approximately 300 , until the ends are flush with the long angled edge.
Page 4
Step 4: Stand the assembly on its legs and secure the Arm (C) to the Back Leg (A) using the upper 2 holes on the Back Leg (the back edge of the arm should be flush with the edge of the Back Leg). Use a screw into the third hole on the Back Leg (A) to secure the small triangular block to the Back Leg (A).