Advertisement
IMPORTANT INSTRUCTIONS: Read This Before Using TreeFrog Products
WARNING: Ski&Snowboard racks falling in the road саn cause serious accidents resulting in
bodily injury-do not use rack оn any vehicle оn which it саn not bе properly mounted as described in
this instruction manual.
• AII the TreeFrog vacuum mounts must bе fully mounted completely to the metal, glass, or
fibreglass surface - never attached to rubber or plastic moldings.
• Only the TreeFrog rubber vacuum mounts should bе attached to the vehicle. Never use rack on
trailers or оn the front of vehicles.
• Do not use if any part of the rack is damaged, worn, or missing. Contact to
www.treefrogracks.eu
• Clean the саг mounting surface with the TreeFrog towel and the rubber vacuum pads with clean
water before mounting the rack to the vehicle.
• Make sure that the rack's rubber vacuum pads are fully mounted to the surface, and that all the
vacuum pumps fully seated.
• Check the vacuum pump white indicator band during use.
• lf the rack 's vacuum cups hold full vacuum seal for at least 3 hours, do not use the rack. Dо the
maintenance, and test it before use it again!
• Lube the vacuum pumps regularly.
• Dо not use if the indicator band is exposed оn аnу of your pumps.
• Dо not exceed the posted speed limit. Speed limits must under no circumstances exceed
130 km /h.
Ski&Snowboard Rack and Carrier Series
for replacement parts.
Owner's Manual
1. Safety first
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Summary of Contents for Tree Frogs Ski&Snowboard Series
- Page 1 Owner's Manual Ski&Snowboard Rack and Carrier Series IMPORTANT INSTRUCTIONS: Read This Before Using TreeFrog Products WARNING: Ski&Snowboard racks falling in the road саn cause serious accidents resulting in bodily injury-do not use rack оn any vehicle оn which it саn not bе properly mounted as described in this instruction manual.
- Page 2 • Regularly inspect screws, nuts, and bolts after every couple of use, and retighten if necessary. • Skis and snowboards need to ride front to back оn the vehicle, not side to side. • Test security bу pushing and pulling оn carriers. •...
- Page 3 3. Assembly All the Ski&Snowboard racks need minor assembly prior to use. The Ski&Snowboard racks that come with 4 TreeFrog vacuum mounts are not attached to the ski carrier. First unscrew the 2 bolts at the vacuum mount housing sides with the 5 mm hex key. Then place the ski carrier hinge over the mounting holes, and push it all the way down.
- Page 4 CAUTION: • Never put water оn the vacuum cups when the weather temperature could go below 0 Celsius! • ln low temperatures, the rubber vacuum pads may become stiffer. When removing your rack, please store it at room temperature (or at least above 15 Celsius) before remounting it. •...
- Page 5 to, misuse, overloading, or from failure to assemble, mount or use the product or its accessories in accordance with TreeFrog's written instruction, guidelines, and safety text. Nor does it cover damage to the user's vehicle, electronic devices, cargo, or to any other person or property. 8.
Need help?
Do you have a question about the Ski&Snowboard Series and is the answer not in the manual?
Questions and answers