Table of Contents
Advertisement
Quick Links
Hammock on Wooden Stand
Caution: You must read this before you proceed
CAUTION : Do Not Swing on or in Hammock. This could cause the product to tip over
resulting in possible injury.
This Hammock on Wooden Stand is NOT a TOY.
Keep your child / children at bay in the process of assembly.
Have at least three adults to assit when assembling this Hammock on Wooden Stand.
Label
A
B
C
M
O
Picture
Picture
Description
Supporting Bar
Mid-Joint Support Bar
Ground Bar
Hammock
Rope with Carabiners
QTY
2
2
2
1
4
1 OF 8
Advertisement
Table of Contents
Summary of Contents for HOMEDEPOT Hammock on Wooden Stand
- Page 1 This Hammock on Wooden Stand is NOT a TOY. Keep your child / children at bay in the process of assembly. Have at least three adults to assit when assembling this Hammock on Wooden Stand. Label Picture...
- Page 2 Label Picture Description Bolt (M10*13CM) Washer Bucket Wrench Bolt (M10X23CM) Metal Chain with Iron Carabiners Eye Bolt (M10*60MM) Bolt and Ring Nut (M8*15MM) Allen Key Bolt and Ring Nut (M8*11CM) Before Beginning Assembly: 2 OF 8...
- Page 3 This Hammock has multiple parts and may require up to 60 minutes to assemble. To give you an overview of the Hammock parts, the above picture is to help you put the various parts into perspective. Please read through the instructions below to familiarise yourself with the parts and steps before assembly.
- Page 4 Step 2 NOTE : Have a couple of partners / assistants when assembling this step. Put Supporting Bars(A) between Mid-Joint Supporting Bars(B). Then attach using Bolts(H), Washers(E) and Nuts(F) with Bucket Wrenches(L). Tighten the Bolts in a sequential manner until fully secure. Step 3 NOTE : This step should...
- Page 5 Step 4 Attach the Eye Bolts(K) to the tail end of the Supporting Bars(A) using Washers(E) and Nuts(F) with Bucket Wrench(L). Tighten the Bolts in a sequential manner until fully secure. Note: The Eye Bolts should be facing the inside of the frame assembly, as pictured. Step 5 Screw the Bolt and Ring Nuts(Q) to the four ends of the Wooden Support Rails with Allen Key(R)
- Page 6 Step 6 Insert the Bolt and Ring Nuts(N) into the Supporting Bars(A), as shown in the picture. Tighten the Bolts of this step completely by hand. Step 7 Hook the Chain with Carabiners(J) to the Loops at the ends of the Hammock(M). 6 OF 8...
- Page 7 Always be careful of your safety when getting on and off of the Hammock; children should not be allowed on the Hammock without adult supervision. This Hammock on Wooden Stand can only be used on a flat, level surface. 7 OF 8...
- Page 8 8 OF 8...
Need help?
Do you have a question about the Hammock on Wooden Stand and is the answer not in the manual?
Questions and answers