Advertisement
Quick Links
Single Pole Timers
MODEL
HET06-R
1. For your safety, connecting a proper ground to the timer switch provides protection against electrical shock in the event of
certain fault conditions
2. If a proper ground is not available, consult with a qualified electrician before continuing installation
3. Only connect the HET06-R to a Single Pole Circuit. The HET06-R is not suitable for 3-way switching.
4. If the existing wiring does not match the description for a Single Pole Circuit, you should consult with a qualified electrician
CAUTION
PLEASE READ INSTRUCTION BEFORE COMMENCING INSTALLATION AND RETAIN FOR FUTURE REFERENCES.
Electrical products can cause death or injury, or damage to property.
If in any doubt about the installation or use of this product, consult a competent electrician.
INSTALLATION GUIDE
Wire the timer switch
• Twist the existing wires together with the wire leads on the timer switch as indicated in the drawing above.
Cap them securely using the wire nuts provided
• Connect the green or non-insulated (copper) GROUND wire from the circuit to the GROUND wire on the HET06-R
• Connect the power wire from the circuit (HOT) to the black wire on the HET06-R
• Connect the power wire to the lamp or fan (LOAD) to the red wire on the HET06-R
• Connect the NEUTRAL wires from the circuit (NEUTRAL) to the white wire on the HET06-R
• Please check the presence of neutral wire, and do not connect neutral with load wire together
info@ortechindustries.com
www.ortechindustries.com
WARNING
WARNING — THE INSTALLATION MUST BE CARRIED OUT BY
A QUALIFIED ELECTRICIAN.
1. These Single Pole Timers are suitable for indoor use only
2. Please keep the Single Pole Timers away from any corrosive substance, and please use
dry cloth when you clean it
3. Single Pole Timers can only be installed by a qualified electrician
4. Before installation or maintenance, please turn off the circuit breaker
Application Notice
13376 Comber Way
Surrey BC V3W 5V9
375 Admiral Blvd
Mississauga
,
ON L5T 2N1
Instruction Manual
1-888-543-6473
1-888-541-6474
Advertisement
Summary of Contents for Ortech HET06-R
- Page 1 Cap them securely using the wire nuts provided • Connect the green or non-insulated (copper) GROUND wire from the circuit to the GROUND wire on the HET06-R • Connect the power wire from the circuit (HOT) to the black wire on the HET06-R •...
- Page 2 The Preset Countdown Timer replaces standard single-pole wall switch for energy savings throughout the home. It turns controlled lights or fans off when the selected time expires. Turning loads ON with the HET06-R is accomplished by pressing the desired time selection or ON/OFF button. After one button is pressed, lights will remain ON for the duration of the selected time delay that was new setting or last setting used.