Page 1
Zubehör Accessories E-DAT modul System 8(8) Cat.6a Modul Staubschutzklappen Montageanleitung E-DAT modul System 8(8) Cat.6a module für E-DAT modul System Dust protection forE-DAT modul System Termination Instructions System Ausführung Bestell-Nr. 24x8 Cat.6a Patchfeld Version E-DAT modul System Ausführung Bestell-Nr. 8(8) Cat.6a Modul...
Page 2
Kabelkonfektion Kabelmontage Cable Preparation Cable Connection System System 7 weiß/white 8 braun/brown 3 weiß/white 6 orange/orange Die Adernpaare weiß/braun und weiß/orange in die un- Kunststoffmantel ca. 25 mm (max. 30 mm) abisolieren. Paar-Schirmfolie einkerben und entfernen. Zum Entfernen der überstehenden Adern einen geeig- teren Öffnungen des Ladestücks einführen ...
Page 3
Kabelmontage Einbauvariante A Einbauvariante B Cable Connection Mounting Version A Mounting Version B System Beim Zusammenfügen der Gehäuseteile, das Ladestück Das fertig angeschlossene Modul von hinten am oberen Montagevorbereitung ... und nach unten einrasten. gerade auf das Gehäuseunterteil setzen. Teil der Modulaufnahme einhaken und nach unten ein- ...
Page 4
Detach Retaining Plates Wire termination: To remove the module retaining plate open the label IDC by BTR: window and insert a small flat screwdriver into the wire 0.4 - 0.65 mm AWG 26 - 22 upper opening and rotate the screwdriver …...