Advertisement
2. INTRODUCTION
All steel stand with pin and chain load support. Full width V-crutch for safe support of loads. All models manufactured to rigorous safety
standards. Sold in pairs.
3. SPECIFICATION
Model No. .........................AS3000.V3.....................................AS5000.V2....................................AS5000M.V2
Capacity Each....................2.5tonne (2,500 kg)........................5tonne (5,000 kg)..........................5tonne (5,000 kg)
Capacity Pair......................5tonne (5,000 kg)...........................10tonne (10,000 kg).....................10tonne (10,000 kg)
Min. Height:........................450mm...........................................320mm...........................................455mm
Max. Height::..................... 705mm...........................................500mm...........................................710mm
Model No...........................AS7500.V2.....................................AS10000...................................... AS12000
Capacity Each....................7.5tonne (7,500 kg)........................10tonne (10,000 kg)......................12tonne (12,000 kg)
Capacity Pair......................15tonne (15,000 kg)......................20tonne (20,000 kg)......................24tonne (24,000 kg)
Min. Height:........................490mm...........................................500mm...........................................515mm
Max. Height::......................730mm...........................................740mm...........................................755mm
4. OPERATION
Refer to vehicle manufactures instructions for recommended support points.
Check that the points are in good condition.
4.1. Ensure the vehicle brake is on (or in park mode) and wheels are chocked.
4.2. Adjust height of stand to correspond with the raised vehicle.
4.3. Check that the locking pin is correctly pushed all the way through the centre column
and out of the other side, then position stands under vehicle at points recommended by
vehicle manufacturer.
4.4. Lower the load onto stands carefully and slowly. Ensure the load bearing points sit in
the center of the stand saddle and check that the stands are stable. Also ensure that
there are no objects or persons that could impede the safe lowering of the vehicle onto
the stands.
4.5. To remove stands jack vehicle slightly so that stand can be removed.
4.6. After use, hold the centre column (fig.1.1) firmly when removing the locking pin
(fig.1.3). Failure to do so will allow the center column to fall freely through the main
centre tube which could be dangerous.
WARNING! Ensure you follow all instructions carefully. Failure to note these
‰
warnings may cause damage, serious injury or loss of life.
4.7. Before each use check to ensure stands and stand welds are not cracked, and
that there are no missing and/or damaged parts.
WARNING! Any stand that appears to be damaged in any way must be removed
‰
from service immediately.
5. MAINTENANCE
5.1. Ensure the locking pins are in good order and condition.
5.2. Owing to the potential hazards associated with these stands, do not misuse, or make
any modification to the stands or components.
5.3. It is the responsibility of the stands owner to ensure the operator has read these instructions, and that the operator is familiar with the
stand's use and limitations.
Environmental Protection
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be
sorted, taken to a recycling centre and disposed of in a manner which is compatible with the environment.
When the product becomes completely unserviceable and requires disposal, drain off any fluids (if applicable)
into approved containers and dispose of the product and the fluids according to local regulations.
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMPORTANT: No liability is accepted for incorrect use of this product.
WARRANTY: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
fig.1
Advertisement
