Advertisement
section 4.1.7 on how to expel fluid from the pump.
4.1.6.
once completed, remove the main suction tube from the pump, pour the oil/fluid into a suitable container and dispose of it in
accordance with local authority regulations. Before using the pump again press the
vacuum release valve for 5 seconds to release the vacuum within the pump. This
valve is situated on the top of the unit underneath the handle.
4.1.7.
In the event of fluid entering the inner pump chamber it can be expelled from the unit
as follows. Firstly press the vacuum release valve (fig.4) for 5 seconds to release the
vacuum within the pump. Seal off the fluid entry/pouring hole by placing your hand
over it, then pump the handle up and down several times. Any fluid that has
entered the pump will be expelled from the air valve on the underside of the unit.
4.2.
OtHEr FluidS
4.2.1.
Select and insert the appropriate diameter probe into the fluid to be drained.
4.2.2.
Connect the main suction tube (fig.2) to both the pump inlet and probe (fig.3).
4.2.3.
The operation of the extractor is the
same as described in sections 4.1.5 to
4.1.7
5. maintEnancE
dO nOt store fluids in the TP6908 container. once used to extract fluid, it must be emptied into an approved receptacle as soon as
8
possible.
dO nOt use to extract hazardous or harmful chemicals, solvents, petrol, diesel, kerosene, alkaline or acids. If by chance such fluids
8
are used in the unit, it must be immediately drained and thoroughly cleaned. Use with prohibited fluids will invalidate your warranty.
dO nOt use the unit if it has been dropped or mishandled, check the unit to ensure there is no damage.
8
EnVirOnmEnt PrOtEctiOn
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted, taken to
a recycling centre and disposed of in a manner which is compatible with the environment. When the product becomes completely
unserviceable and requires disposal, drain any fluids (if applicable) into approved containers and dispose of the product and fluids
according to local regulations.
note: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior
notice.
important: no liability is accepted for incorrect use of this product.
Warranty: Guarantee is 12 months from purchase date, proof of which is required for any claim.
Parts support is available for this product. To obtain parts, please log on to
www.sealey.co.uk, email sales@sealey.co.uk or telephone 01284 757500
fig.1
fig.2
fig.3
Pressure
Release
Valve
TP6908 Issue 1 11/12/18
Advertisement
