Master/Slave Mode - Chauvet Slim PAR PRO Pix User Manual

Master/Slave Mode

The Master/Slave mode allows a single SlimPAR Pro Pix product (the "master") to control the actions of
one or more SlimPAR Pro Pix products (the "slaves") without the need of a DMX controller. The master
product will be set to operate in Standalone or with the IRC-6, whereas the slave products will be set to
operate in Slave mode. Once set and connected, the slave products will operate in unison with the master
product. Configure the products as indicated below.
Slave products:
1. Press <MENU> repeatedly until 12CH shows on the display.
2. Press <ENTER>.
3. Set the DMX address to d 001.
4. Connect the DMX input of the first slave product to the DMX output of the master product.
5. Connect the DMX input of the subsequent slave products to the DMX output of the previous slave
product.
6. Finish setting and connecting all the slave products.
Master product:
1. Press <MENU> repeatedly until SET shows on the display.
2. Press <ENTER>.
3. Use <UP> or <DOWN> to select on.
4. Press <ENTER>.
5. Set the master product to operate in standalone or IR mode.
6. Make the master product the first product in the DMX daisy chain.
• Configure all the slave products before connecting the master to the daisy chain.
• Never connect a DMX controller to a DMX string configured for Master/Slave
operation because the controller may interfere with the signals from the master.
• Do not connect more than 10 slaves to the master.
Page 16 of 20
O
SlimPAR Pro Pix User Manual Rev. 1
PERATION