Zempire Bomberpad Instructions page 2

IN STR U CT ION S
BEFORE FIRST USE:
The first time you use a new Bomberpad , it will take longer than normal to
3D
inflate. This is because the mat has been stored in a compressed state for an
extended period of time. We recommend taking the following steps before first
use:
1. Unroll the mat on a flat surface.
2. Fully open the valve (as pictured) and allow the mat to self-inflate for up to 30
mins.
3. Turn the valve to inflate mode (as pictured) and inflate to maximum capacity
by blowing air into the mat by mouth.
4. Once the mat is fully inflated, secure the valve cap and store overnight.
NOTE: Inflation speed will continue to improve with use as the foam will regain
its expanded state "memory".
NORMAL USE:
To Inflate:
1. Unroll the mat on a flat surface.
2. Fully open the valve (as pictured) for maximum airflow. The internal foam will
expand, allowing the mat to self-inflate.
3. When the mat is fully inflated, turn the valve to inflate mode (as pictured).
To obtain extra firmness, blow air into the valve by mouth until the mat has
reached your desired firmness.
4. Secure the outer valve cap.
To Deflate:
1. Open the valve cap and rotate the valve to deflate mode (as pictured).
2. Fold the mat in half, and then in half again, and apply your body weight to
expel as much air as possible.
3. Roll the mat towards the open valve, this will force any remaining air out the
valve.
4. Close the outer cap, secure the rolled mat with the included compression
straps and insert into the carry bag.
NOTE: You may need to roll the mat several times to get all the air out. To
prevent the mat from self-inflating, make sure the valve is turned to deflate
mode.
CARING FOR YOUR MAT:
- For best performance, store the mat flat with the valve open. This will maintain the foam's fully
2
expanded potential. This will also allow any moisture trapped in the interior to escape. If your
mat must be stored in a rolled state, inflate the mat as frequently as is reasonable to prevent
the foam from developing a compressed state "memory".
- If your mat is accidentally punctured, repair with the included adhesive or use a high-quality,
flexible, urethane adhesive.
- To avoid mildew, never store your mat in a damp or wet environment. Be sure your mat is
completely dry before storing.
4
- To clean your mat, use mild soap and warm water. Be sure to close the valve when cleaning to
avoid getting any water into the mat. Let the mat air dry. Never place your mat in a washing
machine or dryer.
- Keep your mat away from any open flames, sparks, embers, hot camp stoves, lanterns or other
high heat sources.
- Avoid using your mat on sharp or abrasive surfaces.
- Do not use an air pump to over-inflate the mat as it may cause irreparable damage.
Please turn page for Warranty information.
2
3
1