Gpi0 Connections For Gpi Control - THOMSON Grass Valley KAM-XM Series Instruction Manual

Installation

GPI0 Connections for GPI Control

18
The KAM-XM modules can receive up to three General Purpose Interface
(GPI) external triggers to automatically activate specific user preset
E-MEM registers configured on the GPI
(page 59). Customer-supplied external GPI triggers are wired through con-
nector J6 (GPIO) on the rear module.
Inputs to the GPI are held high and expect a contact closure to ground to
activate the programmed presets. There is a 100 mA maximum sink to
ground.
Table 3 provides pinouts for the GPI I/O control port, connector J6.
Table 3. Connector GP10 Wiring for GPI Control
GPIO Control
Pin 1
Pin 5
D-9 Female
Pin 6 Pin 9
(page
Pin Connector J6
1 GPI Input 1
2 GPI Input 2
3 GPI Input 3
4 Reserved
5 System Ground
6 System Ground
7 Not Connected
8 Reserved
9 Reserved
KAM-XM-SERIES Instruction Manual
58) and E-MEM web pages