Ultraflex EMEI Electrical And Mechanical Engineering Instructions page 14

VEHICLE G 264-l
Issue 1, May 92
crank-pin and Allen screw into the crank-
shaft. Tighten the Allen screw securely.
f. Install two new O-rings onto the manifold
bridge and fit the cylinder heads to the ends
(see Fig. 9). Fit the inlet and exhaust valves
in the head and retain in position by the new
gaskets and valve plate. Install the cylinder
heads complete with the manifold bridge.
g. Install the eight cylinder head screws and
tighten them securely.
ELECTRICAL AND MECHANICAL
ENGINEERING INSTRUCTIONS
h. Fill the crankcase to approximately two
thirds full with a suitable grease, install a
new gasket on the crankcase then fit the
end cover. Install the four Allen screws and
tighten securely.
i. Install the sealing blocks in the cylinder
heads, then install the remote breather
pipe.
j.
Install the compressor (refer to EMEI VEH
G 263 - GROUP 1).