Flying Industry Development S1X2-DC Quick Manual

RF Wireless Remote Control Radio Controller / Transmitter & Receiver
Package Include:
1 x Receiver: S1X2-DC (1 Channel / Four control Modes)
1 x Transmitter: C-2
1 x User manual
Feature:
Wireless control, easy to install
Direct power output; control Lights, Motors, Fans, electrically operated Doors/Locks/Windows/Blinds/Cars or Other Appliances.
You can turn on/off the recei v er with transmitter (remote control) from any place w ithin a reliable distance; the w i r eless RF signal can pass
through walls, floors and doors.
With characteristics of reverse power protection and over current protection
Audible / visual indication
Use an 8-bit microcontroller w i t h low -power and high-speed CMOS technology.
Reliable control: The transmitter (Encoding) and the receiver (Decoding) use an 8-bit code.
One/ several transmitters can control one/ several receivers simultaneously.
If you use two or more receivers in the same place, you can set them w ith different codes.
It is recommended to use the load w ithin 3A or 50W
Receiver:
Model No.: S1X2-DC
Channel: 1 CH
Pow er Supply (Operating Voltage): DC 6~36V
Output: DC 6~36V
Working Frequency: 315MHz / 433MHz
Control Modes: Momentary, Latched, Toggle, 10 seconds delay
Coding Type: Fixed code or learning code
Coding Setting: By learning
PCB Size: 27mm x 16mm x 7mm
Static Current: ≤6mA
Maximum Working Current: 3A or 50W
Work w ith Fixed code transmitters or Learning code transmitters.
Transmitter:
Model No.: C-2
Channel: 2 CH
Remote Control Distance: 50m / 150ft (theoretically)
Encode: Fixed code by Soldering
Unit size: 58mm x 39mm x 16mm
Pow er Supply: 1 x 23A -12V battery (included, can be used for 12 months)
Usage:
Setting different control modes (We have set the recei v er as Latched mode before delivery. If you want to use other modes, do as following):
1) Setting control mode Momentary: connect terminal 3 and 4.
Press and hold button A: output DC pow er.
Release button A: stop to output.
2) Setting control mode Latched: connect terminal 1 and 2.
Press button A: output DC pow er.
Press button B: stop to output.
3) Setting control mode Toggle: Do not connect
Press button A: output DC pow er.
Press button A again: stop to output.
4) Setting control mode of 10 seconds delay: connect terminal 1 and 2, and connect terminal 3 and 4.
Press button A: output DC pow er.
After 10 seconds delay, stop to output.
Delete all transmitters:
We have learned remote control to the receiver. I f you don't want the recei v er to work with the remote control, you can delete all codes of remote
control s , which are stored in the receiver.
Operation: connect setting terminals until LED on then off; that means all stored codes have been deleted successfully.
Learning the button of remote control:
SHENZHEN GUIYUAN INDUSTRY DEVELOPMENT CO.,LTD
Http://www.carymart.com E-Mail: sale@carymart.com