MaxPac X-Class Setting Up

Hide thumbs

Setting-Up Your MaxPac

Location

Your MaxPac X-Class system needs to be positioned in a location with the capacity to safely

support at least 38 lbs to 75 lbs depending on its configuration. The unit should be unobstructed so

as to permit the free flow of cooling air through the intake fans at the sides of the unit and exhaust

air from the vents at the front of the unit.

Power Requirements

MaxPac X-Class power supplies are auto-sensing 100 to 240 VAC, 50 to 60Hz units. Ensure that the

supplied power is sufficient, stable, and without spikes or surges for operation of your MaxPac and

other required equipment.

Accessing and Connecting the Keyboard, Mouse, etc.

1) Stand the MaxPac system upright on the table and observe the two front cover release buttons,

one on either side of the system (Figure 1-6).

Table of Contents

Need help?

Do you have a question about the X-Class and is the answer not in the manual?

Questions and answers

Summary of Contents for MaxPac X-Class

Page 1 Power Requirements MaxPac X-Class power supplies are auto-sensing 100 to 240 VAC, 50 to 60Hz units. Ensure that the supplied power is sufficient, stable, and without spikes or surges for operation of your MaxPac and other required equipment.
Page 2 Figure 1-6 Figure 1-7 2) Place your hands either side of the system, press the front cover release buttons, and pull the front cover away from the main system (Figure 1-7). 3) Pull the front cover clear of the system and place it face down on the desktop (Figure 1-8). 4) Insert your thumb and index finger into the two holes located toward the center of the inside cover and gently pull this inside cover up and away to reveal the keyboard, mouse, power cable, and DVI-to-VGA connector (Figure 1-9).
Page 3 Figure 1-10 Figure 1-11 6) Plug the keyboard into the PS2 connector in the lower right-hand corner of the main interface panel, which is on the right-hand side of the system (Figure 1-12). 7) The mouse may be plugged into the PS2 connector located next to the keyboard connector as shown in Figure 1-13.
Page 4 Figure 1-15 A single screen system 9) In the case of a single-display system, you may now proceed to the Powering-up Your MaxPac. A dual screen system 10) If you have a dual-screen system, press down on the release catch located at the lower left-hand side of the system (Figure 1-15).
Page 5 A triple screen system 12) If you have a triple-screen system, press down on the release catch located at the lower right- hand side of the system (Figure 1-18). 13) While continuing to press down on the release catch, pull the third screen away from the system until it is completely unfolded (Figure 1-19).