Advertisement
Operating Instructions
Orbital Sander
WARNING
In order to reduce the risk of injury, the operating instructions and safety
regulations must have been read and understood!
Please read the operating instructions in full and for your own safety follow all of the instructions
contained therein.
Store the manual in a secure location.
Attention!
Remember that in accordance with the safety provisions of the Machinery Directive, a compressed air connec-
tion must not be made directly to the air inlet of the compressed air machine. Plug-in sleeves with pressed ends,
screwed into the air inlet of the device provide the greatest level of safety.
© Copyright – AirApp Power Tools GmbH • Siemensstr. 9 – 11 • 40885 Ratingen
Advertisement
Table of Contents
Summary of Contents for AirApp SE1
- Page 1 Plug-in sleeves with pressed ends, screwed into the air inlet of the device provide the greatest level of safety. © Copyright – AirApp Power Tools GmbH • Siemensstr. 9 – 11 • 40885 Ratingen...
- Page 2 Test the orbital sander beforehand in order to identify the appropriate sanding disk. • Sanding performance depends on many factors: If the air flow pressure is below 6.2 bar, performance will be affected. Worn sanding disk. © Copyright – AirApp Power Tools GmbH • Siemensstr. 9 – 11 • 40885 Ratingen...
- Page 3 If you have any questions, please contact the manufacturer. Lubrication of the motor Orbital sanders SE1, SE2, SE4 and SE9 have oil-free motors and must not be lubricated with oil. Disconnect all other orbital sanders from the compressed air in order to prevent accidental activation.
Need help?
Do you have a question about the SE1 and is the answer not in the manual?
Questions and answers