Cautions P - Sharp VH-25 Series Operator's Manual

11. Cautions
A、 Machine Operations:
1、 Check and ensure if the machine bottom and ground base are properly contacted before the
anchor bolts are locked up.
2、 The machine must be installed upon a solid base.
3、 Check and see if the motor voltage and power source voltage are conformed.
4、 Cutters shall be far away from the workpieces when the motor is started or stopped.
5、 Switched off the power source before gear change.
B、 Machine Operatiors:
1、 The machine is be started or operated by an authorized operator only.
2、 Immediate stop and repair are needed in case of troubles in operations.
3、 In installation, the machine shall be connected to earth.
4、 In stop motion, the feed lever shall be placed in the neutral position.
5、 The machine should be stopped during the inspection on the workpieces.
6、 In clamping, check and ensure if the workpieces are firmly vised.
7、 The spindle must be kept clean and lubricated all the time.
8、 Do not place any tools on the work table to maintain its surface preciseness and smoothness.
9、 Prior to cutting, wait until the spindle is running steadily after the motor is started.
10、 Use a brush to clean off the iron fragments.
OPERATOR'S MANUAL
P 56 / 57