Advertisement
Quick Links
Important
• Please unwrap the bath and check it carefully to ensure it has not been damaged in handling or transport.
• The skirted baths come complete with waste and overflow already fitted during manufacture.
• Assemble bath on a mat to protect against damage to bath surface.
• Please do not remove the old fixture before you unpack and inspect the new unit.
• Store the bath in a safe place until you begin installation to avoid damage.
• Any installation should be carried out by a qualified tradesman with knowledge of statutory plumbing requirements in your area.
• This product requires a two person lift – use proper lifting techniques.
• This installation guide does not include details of waste connection; final decision about installation of waste connection should be taken by a suitably qualified person.
Care and Maintenance
Repairing a scratch: If any scratches occur during installation these can be removed by rubbing with a 1500+ grit waterproof abrasive paper and water.
Re-polish the surface afterwards using a neutral automotive colour restorer or household metal polish. For best results limit sanding to the smallest
possible area around the scratch.
It may be possible to polish very fine scratches away without using abrasive papers: scrubbing gently with a soft brush or plastic pad
(not metal scouring pad) and a mildly abrasive cream cleaner. Afterwards scrub the whole area with plenty of clean water and re-polish as before.
It is advisable always to run in some cold water before turning on the hot tap. We recommend the hot water be no more than 65 degrees C.
Extreme heat such as that generated by cigarettes or portable heaters can damage Acrylic surfaces. Do not use such items near your bath.
Everyday cleaning
We recommend a non-abrasive bathroom cleaner.
1
● The floor which the bath sits on must be level.
● Place the bath in the desired position in the bathroom, mark around the bottom
edge of the bath.
2
● The baths have no panel to remove for access to the waste.
There is access under the bath for the connection of the outlet pipe to the trap.
1 - 2
London Round Soaking Tub
London Rectangle Soaking Tub
Waste on bath
E18
E19
A
Advertisement
Related Manuals for Burlington London E18
Summary of Contents for Burlington London E18
- Page 1 London Round Soaking Tub London Rectangle Soaking Tub Important • Please unwrap the bath and check it carefully to ensure it has not been damaged in handling or transport. • The skirted baths come complete with waste and overflow already fitted during manufacture. •...
- Page 2 ● Place the bath on two wooden blocks over the waste connections. ● If you have a waste that comes up through the floor, you can connect to it ● Connect the waste. Fill the bath with water and check for leakage. with a flexible drain pipe which enables you to tilt the bath up and move the bath into the required position.