Advertisement
5.3.
loweriNg
5.3.1.
Turn release valve (fig.2D) to lower lifting frame. Keep feet and hands away from the frame whilst it descends.
5.4.
movemeNt
5.4.1.
Before moving the laden trolley ensure that the wheel is centred on the rollers and restrained by the safety chain (fig.2E) and that
the lifting frame is as low as possible whilst still allowing clearance between tyre and floor.
5.5.
frame width
5.5.1.
the lifting frame rollers can be set to these widths; 440, 496, 560, 610, 668, 724, 780mm. each roller has to be lifted
individually by its outer end so it hinges upwards (see fig.1.1). When the roller bracket is clear of its locking position, slide it along
its hinge pin (fig.1.2) and lower it into the alternative locking positions.
6. maiNteNaNce
6.1.
daily: check for damage and oil leaks. monthly: oil moving parts and grease pedal-to-piston faces. check for abnormal wear and
tear.
warNiNg: do Not use brake fluid, or any fluid other than hydraulic jack oil as this may cause serious damage to the jack and
ˆ
will invalidate the warranty!
6.2.
With lifting frame at lowest point, check hydraulic oil level by removing filler plug (fig.2B). Level should be at bottom of filler hole.
top up, or allow to drain, as necessary. replace plug.
7. fault fiNdiNg
7.1.
Lifting frame does not reach full height - low oil level, check and fill (see 5.1.).
7.2.
foot pump ineffective - oil level too high, check and drain (see 5.1.)
▲
importaNt: No respoNsibility is accepted for iNcorrect use of this product.
Hydraulic products are only repaired by local service agents. We have service/repair agents in all parts of the UK. do Not return
the trolley to us. Please telephone us on 01284 757500 to obtain the address and 'phone number of your local agent. if trolley is
under guarantee contact your local sealey dealer.
de-commissioning the jack
should the jack become completely unserviceable and require disposal, draw off the oil into an approved container and dispose of
the jack and the oil according to local regulations.
recycle unwanted materials instead of disposing of them as waste. all tools, accessories and packaging should be
sorted, taken to a recycling centre and disposed of in a manner which is compatible with the environment.
when the product becomes completely unserviceable and requires disposal, drain off any fluids (if applicable)
into approved containers and dispose of the product and the fluids according to local regulations.
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
importaNt: no liability is accepted for incorrect use of this product.
warraNty: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
fig.1
fig.3
environmental protection
fig.2
Advertisement
