Use; Setting The Browning Level Of The Slice; Using The Various Settings; Maintenance And Storage - Cuisinart CPT160E Instructions Manual

3. USE

Place the toaster on a flat, even surface. Check that the crumb
collector is installed and connect the appliance. Insert bread in
the slot and press the lever. To stop the toaster before the end of
the cycle, press Stop or raise the lever.
N.B. Model CPT180E features  separate control sets, allowing
you to toast  types of bread at the same time. If you wish to
toast 4 slices, both control sets must be used.
A. Setting the browning level of the slice
Turn the control button on the desired level.
The browning of your toasts varies depending on the type of
bread and degree of humidity of the slices. As a general rule, for
medium toasting, set your toaster on level 4-5 to toast denser
bread or fresh bread and on -3 for toasting stale bread.
B. Using the various settings
CONTROLE ELECTRONIQUE
By using the various settings Toast
Reheat you adjust the necessary time depending on the
ELECTRONIC CONTROL
type of bread and toasting level desired. Each setting can be
combined with the browning level control button. For your
facility a light indicator shows the selected setting.
Adds the amount of time necessary to toast more, or
CONTROLE ELECTRONIQUE
to toast bread rolls or thicker slices.
CONTROLE ELECTRONIQUE
Adds the time necessary to first defrost the bread,
ELECTRONIC CONTROL
CONTROLE ELECTRONIQUE
then toast it.
ELECTRONIC CONTROL
Allows to heat up your toasts, without toasting them a
ELECTRONIC CONTROL
second time.
N.B. If you wish to cancel the selection, press Stop. This will stop
the cycle and raise the bread.
CONTROLE ELECTRONIQUE
A few tips...
CONTROLE ELECTRONIQUE
1. Bread rolls, muffins or thick slices should be toasted longer. We
recommend to use the
ELECTRONIC CONTROL
ELECTRONIC CONTROL
level according to your preferences.
. To toast croissants, cut them in half horizontally and select the
setting. To reheat them only, use the
3. When toasting fruit breads, remove any loose fruits from the
surface of the bread in order to prevent fruit pieces from fal-
ling into the toaster or sticking on the guide wires in the slot.
4. If you are toasting a single slice of bread, set the heat selector
to a lighter setting than you normally would.
, Defrost and
CONTROLE ELECTRONIQUE
ELECTRONIC CONTROL
RESET
CONTROLE ELECTRONIQUE
CONTROLE ELECTRONIQUE
ELECTRONIC CONTROL
ELECTRONIC CONTROL
setting, then to set the toasting
RESET
RESET
CONTROLE ELECTRONIQUE
ELECTRONIC CONTROL
setting.
CONTROLE ELECTRONIQUE
ELECTRONIC CONTROL
CONTROLE ELECTRONIQUE
ELECTRONIC CONTROL
RESET

4. MAINTENANCE AND STORAGE

Let the appliance cool down completely and disconnect it
before cleaning. Wipe the the outside of the toaster with a clean
damp cloth, then dry it carefully.
To remove crumbs, slide out the crumb tray and throw the brea-
dcrumbs away, then put the crumb collector back in place. Do
not use the toaster without the crumb collector.
To remove pieces remaining in the toaster, turn it upside down
and shake gently to cause the pieces to drop. Never insert a knife
or any sharp object in the toaster as this could cause damage.

5. SAFETY CAUTIONS

• Do not immerse into water or any other liquid.
• Always disconnect the appliance immediately after use and
before cleaning. Never leave the appliance unattended when
CONTROLE ELECTRONIQUE
CONTROLE ELECTRONIQUE
plugged in. To disconnect, pull out the plug and never the cord.
• Never put your hands inside the appliance. Do not introduce
ELECTRONIC CONTROL
ELECTRONIC CONTROL
too large foods, metallic packaging or any utensil.
• Do not try to free foods when the appliance is connected.
• Do not use the toaster close to inflammable material or under
the wall cupboards of the kitchen.
• Do not let the cord hang over the edge of a table or the kitchen
worktop and avoid any contact with hot surfaces.
• This appliance should not be used by adults or children whose
CONTROLE ELECTRONIQUE
CONTROLE ELECTRONIQUE
lack of experience, product knowledge or disability might
cause a hazard, unless they have been correctly instructed and
ELECTRONIC CONTROL
ELECTRONIC CONTROL
are adequately supervised.
• Children should always be supervised to ensure that they do
not play with this product.
• Do not use the appliance if it has fallen or if it shows noticeable
signs of damage.
• Stop using the appliance immediately if the cord is damaged. If
RESET
the power supply cord is damaged, it should be replaced by the
manufacturer or his after-sales service only.
• Return the appliance to the nearest repair center for inspection,
CONTROLE ELECTRONIQUE
adjustment, electrical or mechanical repair. No repair can be
ELECTRONIC CONTROL carried out by the user.
• This appliance complies with the basic requirements of directi-
ves 04/108/EEC (electromagnetic compatibility) and 06/95/EEC
(safety of domestic electrical appliances) amended by directive
93/68/EEC (CE marking).
RESET
• Use this appliance solely for cooking, following the instructions
CONTROLE ELECTRONIQUE
of this manual.
• Do not use outside.
ELECTRONIC CONTROL
RESET
• For domestic use only.
RESET
RESET
7