Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Summary of Contents for Jacques JEM-4
- Page 1 JEM-4 JACQUES INTERCOM BOX PRODUCT MANUAL JED-0492 jacques.com.au...
- Page 2 Jacques Technologies Pty Ltd does not warrant or make any representations regarding the use, or the results of the use, of the information provided within the publication in terms of its correctness, accuracy, reliability, or otherwise. No oral or written information or advice given by Jacques Technologies Pty Ltd (or by its agents, contractors, distributors, or employees) shall create a warranty or in any way increase the scope of this warranty.
-
Page 3: Table Of Contents
CONTENTS ABBREVIATIONS AND DEFINITIONS ............................4 INTRODUCTION ..................................5 FEATURES .................................... 5 APPLICATIONS ..................................5 OVERVIEW ....................................6 CONNECTION DETAILS ................................7 JIB-4000 REAR CONNECTIONS ............................7 LED CONNECTIONS ................................8 RELAYS CONNECTIONS ..............................9 PERIPHERAL CONNECTIONS ............................10 TECHNICAL SPECIFICATIONS ............................... -
Page 4: Abbreviations And Definitions
Standards Australia and New Zealand European Union Federal Communication Commission IEEE Institute of Electrical and Electronics Engineers Internet Protocol JEM-4 Jacques Ethernet Module Generation 4 Jacques Intercom Box Public Address Power over Ethernet Document Number JED-0492 Revision Page 4 of 18... -
Page 5: Introduction
INTRODUCTION The JEM-4 Jacques Intercom Box (JIB-4000) is an alternative product offering to the standard offering of Jacques panel type intercoms, providing customers a great range of customisation options. The product enables users to interface to a Jacques IP intercom system with a customer supplied arrangement of speaker, microphone, LED and buttons. -
Page 6: Overview
OVERVIEW LINK Figure 2: JIB-4000 Front View The JIB-4000 product features a RJ45 port, LED indicators and a micro USB port on their front panel. See below table for further description. FRONT CONNECTIONS LAN + PoE RJ45 port for Data and Power... -
Page 7: Connection Details
CONNECTION DETAILS JIB-4000 REAR CONNECTIONS Figure 3: JIB-4000 Rear Connections Document Number JED-0492 Revision Page 7 of 18... -
Page 8: Led Connections
LED CONNECTIONS Figure 4: JIB-4000 LED Rear Connections Signal LED common anode (3.3 V d.c.) LED 1 cathode LED 2 cathode Pin 1 Figure 5: LED connection mating plug Document Number JED-0492 Revision Page 8 of 18... -
Page 9: Relays Connections
RELAYS CONNECTIONS Figure 6: JIB-4000 Relay Rear Connections Signal Relay 2 Normally Open (NO) Contact Relay 2 Common (COM) Contact Relay 2 Normally Closed (NC) Contact Relay 1 Normally Open (NO) Contact Relay 1 Common (COM) Contact Relay 1 Normally Closed (NC) Contact... -
Page 10: Peripheral Connections
PERIPHERAL CONNECTIONS Figure 8: JIB-4000 Peripheral Connections Signal Speaker Negative Speaker Positive Audio Ground Audio Input Negative Audio Input Positive Ground Button input 1 Button input 2 Ground +12 V Power Output Pin 1 Figure 9: Peripherals connection mating plug... -
Page 11: Technical Specifications
(AIN+, GND) Analogue Mic Input frequency response (-3 dB) 15.9 Hz - 15.9 kHz Audio codecs Opus, G.711 A-law, G.711 µ-law, G.722, Jacques PCM EXTERNAL CONNECTIONS Ethernet / Power 1 x RJ45 port for Ethernet data and PoE (10/100/1000 Mbit/s) -
Page 12: Safety Warnings
• See Mounting Solutions for methods of mounting a JIB product. • Jacques JIB and optional accessories shall be installed or replaced by trained and qualified personnel only. • Before attempting to install please ensure your package contains the list of specified parts. -
Page 13: Mounting Solutions
MOUNTING SOLUTIONS The following section highlights the available mounting options optionally available for JIB products. Jacques P/N Description 52235 Wall Mounting Kit 52236 DIN Rail Mounting Kit 52237 Eurocard Mounting Kit (accepts two units) Figure 10: Surface Mounting Kit (P/N: 52235) fitted... -
Page 14: Agency Regulatory Notices
2. This device must accept any interference received, including interference that may cause undesired operation. For questions regarding this FCC declaration, contact: Jacques Technologies Pty Ltd PO Box 3542, South Brisbane BC QLD 4101, Australia Or, call +61 7 3846 8400 To identify this product, refer to the Part, Series, or Model number found on the product. -
Page 15: European Union Regulator Notice
Technical Documentation for the assessment of electrical and electronic products with respect to the restriction of hazardous substances. For questions regarding this CE declaration, contact: Jacques Technologies Pty Ltd PO Box 3542, South Brisbane BC QLD 4101, Australia Or, call +61 7 3846 8400 To identify this product, refer to the Part, Series, or Model number found on the product. -
Page 16: Disposal Of Waste Equipment By Users In Private Household In The European Union
DISPOSAL OF WASTE EQUIPMENT BY USERS IN PRIVATE HOUSEHOLD IN THE EUROPEAN UNION This symbol on the product or on its packaging indicates that this product must not be disposed of with your household waste. Instead, it is your responsibility to dispose of your waste equipment by handing it over to a designated collection point for the recycling of waste electrical and electronic equipment. -
Page 17: Country Of Origin - Quality Assurance
COUNTRY OF ORIGIN - QUALITY ASSURANCE Jacques products are developed and manufactured by Jacques Technologies Pty Ltd in Brisbane, Australia. The development and manufacturing processes are certified in accordance with EN ISO 9001:2016. The technical data contained herein has been provided solely for informational purposes and is not legally binding. - Page 18 DOCUMENT REVISION HISTORY REVISION DATE AUTHOR CHANGE DESCRIPTION 2020-09-28 Initial Release Document Number JED-0492 Revision Page 18 of 18...