Do you have a question about the A36951 and is the answer not in the manual?
Questions and answers
Subscribe to Our Youtube Channel
Summary of Contents for AVANT A36951
Page 1
English Drum type concrete mixer 2018 1 Operator's Manual for Attachment Drum type concrete mixer Product number A36951 www.avanttecno.com A432271 2018 1 EN 2018-...
Drum type concrete mixer 2018 1 CONTENTS 1. FOREWORD ............................4 Warning symbols used in this manual ..........................5 2. DESIGNED PURPOSE OF USE ......................6 3. SAFETY INSTRUCTIONS FOR USING THE ATTACHMENT ............7 4. TECHNICAL SPECIFICATIONS ......................11 Safety labels and main components of the attachment.................. 12 5.
If you sell or transfer the equipment, be sure to hand over this manual to the new owner. If the manual is lost or damaged, you can request a new one from your Avant dealer or from the manufacturer.
5 (28) Warning symbols used in this manual The following warning symbols are used throughout this manual. They indicate factors that must be taken into account to reduce the risk of personal injury or damage to property: WARNING: SAFETY ALERT SYMBOL This symbol means: “Warning, be alert! Your safety is involved!”...
6 (28) 2. Designed purpose of use The AVANT Drum type concrete mixer is an attachment suitable for use with AVANT multi purpose loaders shown in Table 1. The concrete mixer is an essential attachment for mixing and transporting concrete, mortar, plaster or similar material even at difficult locations.
7 (28) 3. Safety instructions for using the attachment Please bear in mind that safety is the result of several factors. The loader-attachment combination is highly powerful and improper or careless use or maintenance may cause serious personal injury or property damage.
Page 8
8 (28) The stability of the loader may change when leaving the driver’s seat, leading to tipping over of the machine. Always remember that the boom may lower unexpectedly due to loss of stability, mechanical fault, or if another person operates the controls of the loader, leading to crushing hazard.
Page 9
9 (28) Risk of tipping over - Avoid overload. Loader can tip over when handling too heavy loads, or because of dynamic movements caused by driving with and handling of a heavy WARNING load. Do not extend the telescopic boom when the load approaches the lifting capacity of the loader, or when the loader boom is in horizontal position.
Page 10
10 (28) Remember to wear proper personal protective equipment: The noise level at the driver's seat may exceed 85 dB(A) depending on loader model and operating cycle. Extended exposure to loud noise can cause hearing impairment. Wear hearing protection while working with the loader. ...
12 (28) 4.1 Safety labels and main components of the attachment Listed below are the labels and markings on the attachment. They must be visible and readable on the equipment. Replace any unclear or missing label. New labels are available via your retailer or contact information provided on the cover.
Page 13
Stop the machine before going near it. A420982 Attachment identification plate Table 4 - Drum type concrete mixer - Main components Frame with Avant coupling brackets Multiconnector holder Mixer drum Mixing tools inside drum Gear rim Hydraulic motor drive...
Do not stay in the area between the attachment and the loader. Mount the attachment only on level surface. WARNING Never move or lift an attachment that has not been locked. Avant quick coupling system: Step 1: Lift the quick attach plate locking pins up and turn them backwards into the slot so that they are locked in the upper position.
5.1 Connecting and disconnecting hydraulic hoses On Avant loaders the hydraulic hoses are connected using the multi connector system. If you have an Avant 300-700 series loader with the conventional quick couplers and wish to change to the multi connector system, contact your Avant dealer or service point for instructions or installation services.
Page 16
16 (28) Keep all fittings as clean as possible; use the protective caps on both the attachment and the loader. Dirt, ice, etc. may make using the fittings significantly more difficult. Never leave the hoses hanging on the ground; place the couplings onto the holder on the attachment.
17 (28) 6. Operating the attachment Check the attachment and the operating environment once more before starting to work, and that all obstacles have been removed from the operating area. Quick inspection of the equipment and the operating area before use are parts of ensuring safety and the best performance of the equipment.
18 (28) Risk of inhaled dust - Use respirator mask as needed. Handling of cement, sand, and other materials related to the typical use of the concrete mixer can WARNING cause spreading of dust. Wear respirator mask when handling loose materials to avoid inhaling dust.
19 (28) 6.2 Operator qualification Anyone who intends to use the attachment must: Know the intended use of the attachment. Know how to use the loader safely in different operating conditions. Read and always follow the instructions concerning the use of the attachment in this operator's ...
20 (28) Rotate the concrete mixer slowly during initial filling. The correct final rotating speed for mixing varies depending of the mixed material. The rotating speed should never exceed above one revolution per second. Empty the drum by tilting it with the loader boom while rotating the concrete mixer slowly simultaneously. During emptying, the rotating direction of the concrete mixer can be varied as needed.
21 (28) Risk of tipping over - Avoid overload and keep heavy load close to the loader. A heavy load added to the concrete mixer will affect the balance of the loader and may cause the loader to tip over. Keep the telescopic boom retracted while filling the concrete WARNING mixer.
22 (28) 6.6 Storage of the concrete mixer After thorough cleaning of the mixer, place it on a level surface where the mixer cannot move or tip over by accident. Do not store the attachment directly against the ground; place it on blocks of wood or on a pallet, for example.
Finding any fault means that the hydraulic hose or component must be replaced and the equipment must not be used until it is repaired. Spare parts are available from your nearest AVANT retailer or authorised service point. Leave the repair work to professional service technicians, if you don’t have adequate knowledge and...
24 (28) 7.2 Cleaning of concrete mixer Clean the concrete mixer immediately after use. Use a water hose to clean the inside drum. Unload any remaining material from the mixer to a suitable place, any material left in the drum will dry and build up even more material.
25 (28) 8. Warranty terms Avant Tecno Oy grants a warranty of one year (12 months) from the date of purchase for the attachment it manufactures. The warranty covers repair costs as follows: Work costs are covered, if the repair is not performed at the factory.
Page 26
SFS-EN ISO 12100, SFS-EN ISO 4413 Mallit / Modeller / Models: Avant Hydraulitoiminen betoninsekoitin; Avant-kuormaajan työlaite Hydraulisk betongblandare; arbetsredskap för Avant lastare A36951 Hydraulic concrete mixer; attachment for Avant loaders 27.9.2018 Ylöjärvi, Finland Risto Käkelä, Toimitusjohtaja / Verkställande direktör / Managing Director Original language version...
Need help?
Do you have a question about the A36951 and is the answer not in the manual?
Questions and answers