HR Noise Detector: quick reference – rev. 1.1
2.4.
POSITION OF THE RECEIVER
Carefully position the receiver according to the specifications below:
• the coil must be directed toward the user;
• the coil must be positioned well away (even a few centimeters) from the LEDs;
• the cable must be folded immediately after the connection on the receiver, so that it does not
pass near the coil;
• the cable, from the receiver to the CPU board connector, should be properly routed in order to
not pass over LEDs or electronic components that may cause interference.
• the receiver must be directed in such a way that its axis of reception is parallel to that of the
transmitter, as shown in the figure below:
Page 2.3