Advertisement
For Use With a Satellite Dish
TV55 Installation Procedure for use with a Satellite Dish
If you have a satellite dish it is possible to install the TV55 using
the same wiring as the satellite dish. To do this you will need to
purchase a set of diplexers (Terk model BDS-P1). The instructions
listed below are for a basic satellite system. If you have a more
complex satellite system and wish to install the TV55 in this
manor please call TERK Support at 1-800-290-6650.
Note: THE POWER-INJECTOR SHOULD NOT BE INSTALLED
WHEN USING A SATELLITE SYSTEM WITH THE TV55.
1. Disconnect the coaxial cable from your satellite dish's LNB.
2. Reconnect this coaxial cable to the outdoor diplexer on the
3. Connect the RG6 coaxial cable downlead from the TV55's "F"-
4. Disconnect the coaxial cable from your Satellite Receivers
5. Connect an RG6 coaxial cable from the INDOOR diplexer-port
6. Connect an RG6 coaxial cable from the satellite receiver port
Note: For assistance locating any antenna accessories not
included with this product please call our Technical Support
Department toll-free at 1-800-290-6650 Monday through Friday
9:00AM to 5:00 PM EST or contact us at www.audiovox.com.
17
terminal labeled "SAT/ANT".
connector to an OUTDOOR diplexer-port (not included) labeled
"ANT". Connect the remaining coaxial cable from the LNB to
the diplexer-port labeled "SAT". (The ports on all of the
diplexers are "F"-connectors.)
"SAT-IN" Terminal and reconnect it to an Indoor Diplexer (not
included) "TV/SAT"
labeled "SAT" to the "F"-connector port on the back of the
satellite receiver labeled "SAT-IN". Connect an RG6 coaxial
cable from the INDOOR diplexer-port labeled "TV" to the "F"-
connector port on the back of the satellite receiver labeled
"ANT IN".
labeled OUT-TO-TV to the "F"-connector port at the back of the
"TV" labeled "ANT-IN".
Advertisement
