Preparing For Use - nature7 ORIENT Translation Of Original User's Manual

III. Preparing for use
S TE P 1
Insert the DC connector of the power
cable into the socket on the underside
of base and then stand the appliance on
a firm level surface (fig. 2).
S TE P 2
Remove the outer cover and pour fresh
clean tap water into the water tank. It is
recommended to leave the water to stand
for a while to allow chlorine to evaporate
out of it. The water that is used should
not be too hard. Make sure that the water
level is not above the maximum water
level mark and then add 2-3 drops of
essential oil into the water (fig. 3).
DO NOT FILL THE WATER PA S T
THE M A X. WATER LE V EL M A RK.
GB
28
S TE P 3
Put the inner cover on to the appliance
and then the outer cover (fig. 4).
S TE P 4
Insert the power adapter plug into
a mains socket with voltage (fig. 5).
Control buttons
MIS T G E N E R ATION
CONTROL BU T TON
(mist generation operating modes – fig. 6)
First press: Continuous mist generation.
Second press: Interrupted mist generati-
on with approx. 30-second pauses.
Third press: Generate mist off.
NOTE
The aroma diffuser can be used in the
mist generation mode without the light.
•
AT TENTION
• The appliance will automatically turn
off if there is an insufficient amount of
water in the water tank.
• Do not tilt the appliance or pour water
out of it through the mist outlet in the
cover while it is in operation.
LIG HT
CONTROL BU T TON
(light operating modes – fig. 7)
First press: Gradually changes colours.
Pressing the button: Sets the individual
colours as required.
After the last colour has been set, pre-
ssing the button will turn off the light.
Holding down the button:
Turns off the light.
NOTE
The light can be turned on and the colour
can be set even when there is no water in
the water tank.
GB
29