Advertisement
III. POWER
LOCK
MECHANISM
MOUNTING:
1. Refer to mounting illustration for POWER LOCK MECHANISM.
2. Select mounting location insKje door that will not interfere with WINDOW.
WINDOW MOVEMENT, DOOR MECHANISM or any other part within the door.
3. Make certain thls location will enable connection
of the POWER LOCK
MECHANISM to the existing door lock button mechanism as shown.
4. Once selected, use one of the two possible mounting methods shown (direct
mounting to door frame method or use of mounting support strap method).
5. Once the mounting method Is decided on, install the POWER LOCK MECHA-
NISMS in each door using the hardware shown in the applicable drawing.
NOTE: Use 5-wire locks in front doors and 2-wire locks in rear doors.
IV.
CONNECTION
OF POWER
DOOR
LOCK
MECHANISM
TO DOOR
LOCK:
1. Refer to drawings for the possible connection methods depending on type of
existing door lock and the location of the existing door button rod that joins the
button to the door lock.
2. Assemble as follows:
a) Place CONNECTING ROD threw the hole in the POWER LOCK MECHA-
NISM plunger as shown.
b) Bend CONNECTING ROD as necessary to reach the existing door button
rod.
c) Place the CONNECTING
ROD ADAPTOR over the existing door button
rod as shown and secure by inserting the 4 x 11 mm hex head screw into
the threaded hole and tightening firmly .
d) Manually move the existing door lock button tram the locked to the
unlocked position and check that the attached mechanism moves smoothly
and the plunger on the POWER
LOCK MECHANISM
extends
and
retracts.
e) Tighten any loose screws.
f) Repeat procedure tor all remaining doors.
CONNECTION METHODS:
UNLOCK
I I
REAR DOOR
LOCK
Ji
LOCK ~
~ UNLOCK
~
I
c
128-4230J
Advertisement
