Gear4 espresso Quick Start Manual

WARNING
To reduce the risk of fire or electric shock, do not expose this unit to rain or moisture.
The apparatus shall not be exposed to dripping or splashing and that no objects filled with liquids, such as vases,
shall be placed on the apparatus.
CAUTION
Use of controls or adjustments of performance or procedures other than those specified may result in hazardous
radiation exposure. Batteries (battery pack or batteries installed) shall not
be exposed to excessive heat such as sunshine, fire or the like.
UNPACKING AND INSTALLATION
Unpack your unit carefully. We recommend that yousave the packaging in case you ever need to store your unit.
To avoid damage, never place the unit or its batteries near radiators, in front of heating vents, under direct
sunlight or near water.
FOR YOUR SAFETY
When disconnecting the power supply, pull the plug first. Do not pull the cord by itself.
•
Never handle the power plug with wet hands, as this could cause fire or electric shock.
•
Refer servicing to qualified personnel only.
•
Do not open the housing.
•
Do not twist or pinch the power supply cord. If the plug or power supply cord needs to be
•
replaced, ensure that it complies with the manufacturer's recommendation.
Unplug the unit during lightning storms and when unused for extended periods of time.
•
Where the MAINS plug or an appliance coupler is used as the disconnect device, the disconnect
•
device shall remain readily operable.
DISPOSAL
According to the European WEEE Directive (2002/96/EC) and Battery Directive (2006/66/EC), all electrical and
electronic products and batteries must be collected separately by a local collection system. Do not dispose of
these items with your normal household waste. Follow local regulations for safe disposal.
The wheeled bin mark indicates that this product should not be disposed with other household
waste throughout the EU. To prevent possible harm to the environment or human health from
uncontrolled waste disposal, recycle it responsibly to promote the sustainable reuse of material
resources. To return your used device, please use the return and collection systems or contact the
retailer where the product was purchased. They can take this product for environmental safe recycling.
FCC RULES
You are cautioned that changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment. This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to part 15 of the FCC rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
•
Consult the dealer or an experienced radio/TV technician for help.
•
FCC RADIATION EXPOSURE STATEMENT
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This
equipment should be installed and operated with minimum distance 20cm between the radiator & your body.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
1) This device may not cause harmful interference and
2) This device must accept any interference received, including interference that may cause undesired operation.
INDUSTRY CANADA
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject
to the following two conditions:
1) This device may not cause interference, and
2) This device must accept any interference, including interference that may cause undesired operation of the device.
Under Industry Canada regulations, this radio transmitter may only operate using an antenna of a type and
maximum (or lesser) gain approved for the transmitter by Industry Canada. To reduce potential radio interference
to other users, the antenna type and its gain should be so chosen that the equivalent isotropically radiated power
(e.i.r.p.) is not more than that necessary for successful communication.
This Class B digital apparatus complies with Canadian ICES-003.
WIRELESS BLUETOOTH SPEAKER
QUICK START GUIDE
Made by
Copyright © 2014 Disruptive Hong Kong Limited.
GEAR4 is a registered trademark of Disruptive Hong Kong Limited. All rights reserved.