Advertisement
ETC Installation Guide
Unison Battery Pack Option Kit
Installation
CAUTION:
Connect Battery Cable
The battery cable is left disconnected when shipped from the factory and should be connected prior to
installation.
1:
Temporarily remove the six screws securing the cover to the battery pack.
2:
Locate the loose red battery cable lead and attach it to the spade connector on the battery.
Note:
3:
Replace the cover and secure it with the six screws previously removed.
Install Battery Pack
1:
Install the wiring harness into the enclosure (the connector is keyed to ensure proper orientation).
Harness installation into the enclosure is similar for both a host DRd and a host ERn enclosure.
a: Insert the connector end through the opening in the bottom of the enclosure. The connector is
designed to snap into place without additional hardware, therefore slight force may be required
to ensure the connector installs properly.
Battery Pack Option Kit Setup Guide
If the battery cable is connected before the enclosure is ready to be energized,
the battery will drain and degrade.
You might find it easier to lift the battery up slightly from the container to fit the lead
onto the spade connector.
Page 2 of 4
ETC
Advertisement
