Repair Instructions
Installing Your Wi-Fi or Blue Tooth Receiver.
Elite Models that Apply: EL04-EL05-LE, Phenom1&2.
Step
Description
Unscrew the (4) screws that attach the control panel to the
1
red case.
Take the plastic cover off of the Velcro, and stick it on the
Left side of the case. (With the wires pointing toward the
2
control panel).
Connect the red and white wire (coupling) with the white
female 4-pronged housing, into the Remote 4-pronged male
connector jack.
3
(If you are installing the Wi-Fi or Blue Tooth Receiver ONLY
with-out the Grand Remote Receive then continue to step
5).
Installing The Wi-Fi or Blue Tooth Receiver And The
20 Function Remote Receivers Into The Same
Machine.
Plug the Female 4-pronged Y-pig-tail into the 4-pronged
4
male remote connector jack.
Plug the Wi-Fi red and white wire (coupling) with the female
4-pronged housing, into one of (it does not matter which
one) the 4-pronged male connector jacks on the Y-pig-tail.
Tools
Picture
Phillips
Screw
Driver
Control Panel - Open
4 pronged Remote connector
Wi-Fi or Blue Tooth red and
white wire couple plugged into
Remote connector jack.
4 pronged Remote connector
jack.
jack.