Advertisement
Table of Contents
Mounting Instructions M-Bus Repeater
AMB8466-M-RP1
1 Overview
The user interface of the AMB8466-M-RP1 consists of 3 LEDs, one button as well as 2 rotary encoding
switches. The button can be reached through a small opening on the front panel with the help of a
suitable pointed object. The rotary encoding switches are found behind the bottom cover (removable)
close to the terminals for the power supply. They are used for setting the operating parameters.
Button
2 Connection
A power supply with a voltage of 12V – 24V DC is connected to the correspondingly marked terminals as
a source of energy.
The bottom terminal cover must be removed to reach the terminals.
Pay attention to the polarity when connecting the power supply!
The connecting leads from the supply terminals must be removed to ensure that the device is
not under voltage.
After connecting the power supply, a LED self test is performed. In the process, all LEDs illuminate once
in the following order: Power Data Error. Afterwards, a device that has already been in operation
changes to normal operation (green Power LED switched on permanently).
AMB8466-M-RP1_MI_EN_1_6.doc
Figure 1 Front panel
Page 1 of 6
Version 1.6
Release: 04.12.2013
Advertisement
Table of Contents
Summary of Contents for Amber Wireless AMB8466-M-RP1
- Page 1 Version 1.6 1 Overview The user interface of the AMB8466-M-RP1 consists of 3 LEDs, one button as well as 2 rotary encoding switches. The button can be reached through a small opening on the front panel with the help of a suitable pointed object.
- Page 2 3 Start-Up A device that is not configured responds by flashing the green Power LED after the power supply has been connected and the LED self test is finished. The index for the wM Bus operating mode and the TX Power can be found in table 1 or 2 (depends on the firmware version).
- Page 3 Figure 2 Rotary encoding switches for wM Bus operating modes, firmware 2.2.0 After the receiving and transmitting operating modes have been set correctly, the button behind the front panel must be pressed briefly to accept the values. When both parameters are accepted, the green LED will flash three more times.
- Page 4 (AMB8465-M, PC and update software). Only AMB8466-M-RP1 with a serial number >= 250 can be updated to this firmware version 2.2.0. Devices from SN 373 on already have this or a newer firmware.
- Page 5 8 LED Display Overview State Definition All LEDs off Interruption to the power supply All LEDs flash one The device is in the start-up phase (“LED self test”) after the other 1 time Green LED on Normal operation Green LED on Data transfer (radio) Yellow LED flashing Green LED flashing...
- Page 6 AMBER wireless GmbH does not assume any liability for the use of its products. Amber wireless GmbH does not grant licenses for its patent rights or for any other of its intellectual property rights or third-party rights. Customers bear responsibility for compliance of systems or units in which AMBER wireless products are integrated with applicable legal regulations.
Need help?
Do you have a question about the AMB8466-M-RP1 and is the answer not in the manual?
Questions and answers