Hama 047454 Operating Instruction

047454
205291
182223
RO
Hama GmbH & Co KG
86652 Monheim /
Service &
Support
www.hama.com
+49 9091 502-0
DG
All listed brands are trademarks of the corresponding companies. Errors and omissions excepted, and
subject to technical changes. Our general terms of delivery and payment are applied.
Germany
G Operating instruction

1. Safety instructions

• Protect the product from moisture.
• Do not leave the SAT finder permanently installed between the SAT dish and the
receiver.
• Take proper safety precautions when working on the roof (risk of falling). If in doubt,
contact a qualified technician and do not attempt to mount the product yourself!
2. Adjusting the SAT system for the best possible reception using the SAT finder
• Disconnect the SAT receiver from the power supply and connect the SAT finder as
shown with the short F cable between the LNB and receiver.
• Reconnect the receiver to the power supply, select a channel.
• Adjust the sensitivity controller (1) until the level jumps.
• Using a protractor and compass, roughly adjust the SAT antenna (SAT dish) accord-
ing to the desired satellites. Search for the proper satellite by turning and panning
the SAT antenna.
• The stronger the incoming SAT signal, the higher the measurement tone that
sounds; the level (needle) on the signal strength display (2) also rises from weak "1"
to medium to strong "10".
• If the level reaches the maximum of "10", turn down the sensitivity controller (1)
until the level shown is reduced.
• Now finely tune the antenna to get as close to the maximum value of "10" as
possible.
• Tighten the antenna fasteners.
• WARNING: The set value can change again when the screws are tightened.
• On your receiver, check if the desired satellite can now be received.
• You can now remove the SAT finder and reconnect the LNB and the receiver.