Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for CommBox 10
Summary of Contents for CommBox 10
- Page 1 CommBox Control Panel 10 User Manual 1.0 Revision: 2...
- Page 2 Table of Contents CommBox Control Panel 10 User Manual 1.0.x In the Box Initial Setup Reconfiguring the Control Panel Enable/Disable Blue Lighting, Reload the UI Enable/Disable Proximity Sensing Switching to Landscape Mode In-Wall Mounting the Control Panel Desk Mounting the Control Panel...
- Page 3 1 CommBox Control Panel 10 User Manual 1.0.x 1.1 In the Box CommBox Control Panel 10, power supply, user manual. Optional in-wall bracket (2 pieces) v. Desk mount sold separately. 1.2 Initial Setup Connect the power and network using one of the following options:...
- Page 4 Configure the network using one of the following options: Ethernet with DHCP: This is the default, so nothing further to do. Note that ethernet will not work if WiFi is enabled. To see the allocated IP address, press "Ethernet" under "WIRELESS & NETWORKS", and the IP Address is shown. Ethernet with Static IP Address: Press "Ethernet"...
- Page 5 1.6 Switching to Landscape Mode CommBox recommends using the 10" panel in portrait mode for best use of space. However, you can run it in landscape more with both the in-wall and desk brackets.
- Page 6 "ROTATION 90 DEGREE". 1.7 In-Wall Mounting the Control Panel The 10" panel is best mounted in portrait, although it can be mounted landscape. The camera holes will be to the left in portrait, and at the top in landscape. The visible part of the Control Panel in front of the wall measures 167mm W x 248mm H x 15mm D (portrait).
- Page 7 Panel 10. Making sure that the finger locking tab is fully extended to the right, push the rear of the Panel 10 into the hole in the centre. The 4 locking tabs should insert into the back of the panel. Push the finger locking tab inwards behind the panel to lock into place.
- Page 8 Screw the 2 supplied screws into the back the Panel 10. If not screwing to the desk, stick the 4 supplied rubber feet to the 4 corners of the base.
Need help?
Do you have a question about the 10 and is the answer not in the manual?
Questions and answers