Advertisement
Advertisement
Table of Contents
Summary of Contents for Creek Audio SEQUEL mk4
- Page 1 SEQUEL mk4 Instruction Manual Plug-in Phono Card V1.1 WWW.CREEKAUDIO.COM...
- Page 2 Remove the top cover and place it carefully away from the amplifier. Remove the plug-in 5-way LINK PCB from the Pre-amp section of the amplifier. This makes room for the Sequel mk4 Phono pre-amp to be fitted, between the 4-way (power supply) and 5-way (input/output) connector.
- Page 3 To match your cartridge there are three pairs of switches located in a block at the left side of the module. Make the selection before replacing the cover on your amp. One pair is the left and right channel. • 1 &...
- Page 4 Sequel mk4 is suitable for use with the following Creek Integrated amps and pre-amps from 1993 onwards. To make sure the Sequel mk4 suits your Creek amplifier, please read the definitive list below: Voyage i20, Evolution 100A and Evolution 50A, Destiny 2, Evolution 2, Evolution 5350, Classic 5350 SE, 5350 SE, 5350 R and 5350, 5250, 5250 R and 5250 SE, 4330, 4330 R and 4330 SE, 4240 and 4240 SE and P42 Pre-amp.
- Page 5 Phono pre-amps should be used. Destiny 1 used a different style of Phono board, but an adapter PCB is now availa- ble that allows the Sequel mk4 fit. Check with Creek Audio for availability. If you are in doubt, check with your dealer or write to info@creekaudio.com for advice.
- Page 6 If within two years of purchase date your Creek Voyage CD proves to be defective for any reason other than accident, misuse, neglect, unauthor- ized modification, or fair wear and tear, Creek Audio Ltd. will, at its discretion, replace the faulty parts without charge for labour or return carriage within the United Kingdom.
Need help?
Do you have a question about the SEQUEL mk4 and is the answer not in the manual?
Questions and answers