Sharp KH-6I19FTPP-EU Manual page 54

as that quoted on the rating plate which
is situated at the back of your hob.
The circuit can support the appliance
load (see the rating plate).
The power supply has a grounded
connection connection, which complies
with the provisions of current regulati-
ons and is in good working order.
The fused switch is easily accessible
once the hob has been installed.
If there is no dedicated hob circuit and
fused switch, they must be installed by
a qualified electrician before the hob is
connected.
An approved suitable cable must be
connected from the Consumer Unit
(main fuse box) and be protected by
fuse suitable rate label or Micro Circuit
Breaker (MCB). The electrician must
provide a fused all pole switch, which
disconnects both the line (live) and
neutral conductors with a contact sepa-
ration of at least 3.0 mm.
The fused switch should be fitted to the
kitchen wall, above the work surface
and to the side of the hob, not above
it, in accordance with IEE regulations.
Connect the fused switch to a junction
box which should be fitted on the wall
about 61cm (24 inches) above floor le-
vel and behind the hob. The hob's po-
wer supply cable can then be connec-
ted. Connect one end to the junction
box and connect the other end to the
hob's power connection box which is
located at the back of the hob. Remove
the cover of the power connection box
and install the cable, in accordance
with the connection diagram.
The power supply cable must be posi-
tioned away from direct heat sources.
It should not be to a temperature rise
of more than 50°C above room tempe-
rature.
for 32A use
3x2,5 mm² 220V~
3x2,5 mm² 230V~
3x2,5 mm² 240V~
for 13, 15, 16A use
3x1,5 mm² 220V~
3x1,5 mm² 230V~
3x1,5 mm² 240V~
••. You will find the connection diagram
shown on the bottom of your applian-
ce.
EN - 16
5
5x1,5 mm² 380V 3N~
5x1,5 mm² 400V 3N~
5x1,5 mm² 415V 3N~
5
5x1,5 mm² 380V 3N~
5x1,5 mm² 400V 3N~
5x1,5 mm² 415V 3N~
5
5