Troubleshooting; Technical Data - Faber FCH 95 BK KL User Manual

When a cooking area is active, it may
hum briefly. This is a characteristic of all
ceramic glass hobs and does not impair
the function or life of the appliance. The

13. TROUBLESHOOTING

Description
Error code
Hob switches off after 10
ER03
sec.
Hob switches off.
ER21
Corresponding
E2
area switches off.
Corresponding
E3
area switches off.
Hob does not switch on. Power supply voltage and/or frequency
E6
Cooking areas are turned
E8
off.
Corresponding
EH
area switches off.
E4
E5
Disconnect the hob from the power supply.
E7
Wait a few seconds, then reconnect the hob to the power supply.
E9
If the problem persists, call the After Sales Service and specify the error code that appears on the display.
ER20
ER22
ER31
ER36
ER42
ER47
EA

14. TECHNICAL DATA

Type of product
Dimensions
Total power
Possible causes of the error
Continuous key activation detected.
Water or pan placed on the control
panel.
The internal temperature of electronic
parts is too high.
cooking Empty or unsuitable pan.
Pan or ceramic glass surface temper-
ature too high.
Electronic component temperature too
high.
cooking Unsuitable pan.
The pan is losing its magnetic proper-
ties and may damage the induction
hob.
is out of range.
Fan fault.
Fan blocked by dust or fibres.
cooking Temperature sensor blocked for cook-
ing area.
Insufficient temperature variation de-
tected after switching on the hob.
Width
Depth
Min./max height
noise depends on the pan used. If it
causes considerable disturbance, it may
help to change the pan.
Solution
Remove water or pan from the ceramic
glass surface and control panel.
Let the hob cool down.
Please check if the hob has sufficient
ventilation.
If the error persists, please contact
After Sales Service.
Let the hob cool down.
Use a suitable pan.
Do not heat empty pans.
Use a suitable pan.
The error is automatically cancelled
after 8 seconds and the cooking area
can be used again.
If any other errors occur, the pan must
be changed.
If the error persists, please contact
After Sales Service.
Check mains voltage and/or fre-
quency.
If necessary, contact After Sales Ser-
vice.
Clean and remove foreign bodies from
the fan.
If the error persists, please contact
After Sales Service.
Switch off the hob and switch it on
again after cooling down.
If the error persists, please contact
After Sales Service.
Unit
mm
mm
mm
W
Value
Built-in Hob
900
520
54
7400
15